When the load current exceeds the SCR current rating, SCRs are connected in parallel to share the load current. Further the holding currents of the devices should not be so much different that at reduced load current one of the device gets turned-off because of fall of current through it blow its holding current value.
sex
Parallel to each other.
pair of for layer of SCRS
IF two dc sources are connected in parallel, the one with the highest potential dominates the circuit.
choke is connected in series not parallel.lol
street lights are connected in parallel mostly because if any lamp stops glowing but the other lamps continue their glow
Resistance is connected in parallel with voltmeter or say, voltmeter is connected in parallel with resistance.
Home devices are connected in parallel and not in series.
All home appliances are connected in parallel.
"What is the functioning procedure of full wave rectifier by using SCRs?" "What is the functioning procedure of full wave rectifier by using SCRs?"
In principle, it is infinite. I have not connected a parallel circuit in ages.
A voltmeter can be connected in parallel with a resistor to show the voltage across the resistor.
Parallel to each other.
high voltage field windings are connected in parallel
they are not always connected in series, yes most are for circuit amplification purposes, but some SCR's are just used as an electronic switch by themselves. An example is copier circuits, they use alot of them in single use applications.
a parallel bulb is one that is connected in parallel with respect to the source voltage
Because the ammeter connected in parallel will act as a short circuit.
An ammeter is connected in series. A voltmeter is connected in parallel. ammeter should always be connected in series instead of parallel becoz it is a low resistance device and we know that resistance is inversly proportional to current so more current will pass through it and if it is connected in parallel than it may get damaged