Tags Electronics Engineering

Animals & Plants Arts & Entertainment Auto Beauty & Health Books and Literature Business Electronics Engineering & Technology Food & Drink History Hobbies Jobs & Education Law & Government Math People & Society Science Social Studies Sports Travel & Places

0

Subjects>Engineering & Technology>Electrical Engineering

Why the te0 mode is the dominant mode in rectangular waveguide?

Updated: 4/28/2022

Wiki User

∙ 10y ago

Best Answer

Because it has the lowest cut-off frequency (highest cut off wavelength) for a>b o

Wiki User

∙ 10y ago

This answer is:

Add your answer:

Earn +20 pts

Q: Why the te0 mode is the dominant mode in rectangular waveguide?

Write your answer...

Submit

Still have questions?

imp

Continue Learning about Electrical Engineering

Related questions

What is TE interface in cisco?

A TenGigabitEthernet interface can be abbreviated as Te at the command line. For example Te0/0/1 equals interface TenGigabitEthernet0/slot0/port1.

Trending Questions

How has electricity changed peoples lives? What transmits electricity like copper? Why ce configuration of transistor has a 180 phrase difference in output? What is the actual measured resistance of the circuit if the Vom is set to the R x 100 range and the meter face reads 22.5? IS ASIC field programmable? How do you write the Boolean expression for XOR gate? What size breaker would you need for 15 ton R.T.U? Does a transformer convert the current from 240 volts to 120 volt? Why overhead lines are far cheaper than underground cables for long distances and less economical for short distances? What is the frequency of the power waveform in capacitive circuit? Circuit for single tuned amplifier? What is the opposite to an amplifier? What is an electrical power inverter? What is the definition of myoelectric? How many times in each second does electrical current change in an electric power grid? What Did the Electrician say After Fixing a Light Bulb at the Top of the Ewpire state Buildingt answers? Why phase current is equal to line current in star connection? What is the resistance of an air gap? When must give a signal either by hand and arm or by a signal device? Can a defective diode be repaired and reused?

Still have questions?

imp

Previously Viewed

Why the te0 mode is the dominant mode in rectangular waveguide?

Resources

Top Categories

Product

Company

Copyright ©2024 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.