the resitance would be used to reduce a voltage amplitude to a level suitable to be used in an application, to limit the amount of current flowing within the circuit , or in some cases the resistor
could be used as a heating - effect.
The use of a resistance box or a "Decade Box" is to help calibrate instruments used to measure electrical values such as Voltage, Current, and Resistance. Without them you would not have a known value of resistance to use as a set point.
H
use kvl or kcl
A item's resistance is not able to be changed with water. Water on an object or absorbed by an object can change the overall resistance of an object by putting in parallel the resistance of the water itself. If you were to use very clean water that was deionized and soaked your device, you would see no resistance change.
The ac resistance of a diode is found using the equation: (The change in Vd)/(The change in Id) An easier was is to use the Equation: 26mV / Id. This is a general form as the ac resistance of a diode change as the temperature changes.
we use it when we require a variable resistance in a circuit
Resistance is futile!
no we not use resistance in place of diode.
The use of a resistance box or a "Decade Box" is to help calibrate instruments used to measure electrical values such as Voltage, Current, and Resistance. Without them you would not have a known value of resistance to use as a set point.
The electricities resistance stops the electric circuit.
Gandhiji asked the people to use 'Non-violence' as a resistance.
Resistance doesn't "use" either. Resistance is the division of voltage by current. It can be though of as a measure of how hard it is to push electrons through a substance.
Population resistance is also known as pesticide resistance. Pesticide resistance describes a pest population's increasing resistance to a pesticide that use to be effective in terminating said pests.
A parachute.
Yes, this bike does use magnetic resistance. Specifically, it is an electromagnetic resistance system. There are manual or 11 programmed choices to vary the resistance. All you have to do is press the appropriate buttons on the user control panel. Your selection will be reflected on the LED screen.
To measure resistance, you could use an ohmmeter. But ohmmeters are not particularly accurate, so other methods are preferable. These include the use of Wheatstone's Bridge (which compares the unknown resistance with known values) or a Ducter (for very low resistances).
Removing side mirrors from a car will lower it's air resistance.