0
What else can I help you with?
What does nick mean when he says that tolerance has a limit?
Tolerance has a limit means tolerance is a capability and every capability has a limit
What is tolerance limit?
The expected range of measurements produced by a given operation.
How do you convert basic tolerance to bilateral tolerance?
To convert basic tolerance to bilateral tolerance, you take the basic tolerance value and apply it symmetrically around the nominal dimension. For instance, if the nominal dimension is 100 mm and the basic tolerance is ±0.5 mm, the bilateral tolerance would be 100.5 mm (upper limit) and 99.5 mm (lower limit). This means the dimension can vary by the same amount in both directions from the nominal value, ensuring that it stays within the specified range.
What is h9 tolerance limit for a 8mm diameter shaft?
UPPER TOLERANCE: 0.0MM LOWER TOLERANCE: -.062MM Source: Michelin Quality Requirements Manual 1993
What is mechanical tolerance?
Mechanical tolerance is the permissible limits or limits of variation in physical dimension. This can also be defined as the limit between a bolt and a nut.
What is the tolerance for a diameter 10H12 hole?
The tolerance for a diameter 10H12 hole indicates that the hole is specified with a nominal diameter of 10 mm and a tolerance class of H12. In this case, the "H" signifies that the hole is a basic hole, and the "12" denotes the tolerance grade, which typically corresponds to a specific range of permissible diameters. For a 10H12 hole, the upper limit is 10.025 mm and the lower limit is 10.000 mm, allowing for a tolerance of +0.025 mm.
What is the meaning of tolerance as applied to a dimension?
Tolerance is the allowable variation for any given size in order to achieve a proper function. Tolerance equals the difference between lower and upper limit dimensions. For example; for 0.500-0.506 inch the tolerance would be 0.006 inches.
What is the tolerance for a 130 H7 hole?
The tolerance for a 130 H7 hole specifies the permissible limits of its size. For a hole with a nominal diameter of 130 mm and a tolerance grade of H7, the hole's upper limit is 130 mm and the lower limit is 130 mm minus 0.021 mm, resulting in a tolerance range of 130.000 mm to 129.979 mm. This means the hole can be between these two measurements to maintain its H7 designation.
What is the upper control limit of a 1 ohm resistor with a 20 percent tolerance?
A 1 ohm 20% tolerance resistor should not exceed 1.2 ohms actual resistance.
What has the author Chang-chung Li written?
Chang-chung Li has written: 'A comparison of efficiency and robustness for lower tolerance limit procedures' -- subject(s): Statistical tolerance regions
What is the ordinary and maximum tolerance limit of sound by human beings?
The ordinary tolerance limit for sound by human beings is around 85 decibels. Prolonged exposure to sounds higher than 85 decibels can cause hearing damage. The maximum limit before pain begins is around 120-130 decibels.
A resistor of 10k ohms resistance with tolerance of 5 percent is connected in parallel with another resistor of 5k ohms resistance and 10 percent tolerance.what is tolerance limit of parallel network?
6.67%
