A 4000-Ω resistor is connected across 220 V will have a current flow of 0.055 A.
Ohm's law: Voltage equals Current times Resistance
Four 1000 ohm resistors in series have an effective resistance of 4000 ohms. Across a 4 volt voltage source, they would have a current of 1 mA, with a power dissipation of 4mW.
To find the resistance of the circuit, you can use Ohm's Law, which states that ( R = \frac{V}{I} ), where ( R ) is resistance, ( V ) is voltage, and ( I ) is current. Given that the current ( I ) is 0.0030 A and the voltage ( V ) is 12 V, the resistance ( R ) can be calculated as follows: [ R = \frac{12 , \text{V}}{0.0030 , \text{A}} = 4000 , \Omega. ] Thus, the resistance of the circuit is 4000 ohms (or 4 kΩ).
CT ratio is the ratio of primary (input) current to secondary (output) current. A CT with a listed ratio of 4000:1 would provide 1A of output current, when the primary current was 4000A.
Start with 2000 of P then add 1000 of S an at the end add 1000 of I mix it very good .After about 45 days you will have 4000 p,s and I which stand for 4000 PSI
700 pounds
Four 1000 ohm resistors in series have an effective resistance of 4000 ohms. Across a 4 volt voltage source, they would have a current of 1 mA, with a power dissipation of 4mW.
Using ohm's law, V=IR then R=V/I =6/0.0015=4000 ohm = 4k ohm resistor.
use ohm s law ( v =rxi ) ( i =v/r) ( r=v/i) therefore your answer is 10v/4000=.0025amps
The selection of CT Sizing is based on total connected load. If for example a Main CB of 2000 KVA Trafo is 4000 A -- then best selection would be 4000:5 -- this would match also in the Energy Meter (KWH Meter) with 800 as multiplier.
The distance across Australia, travelling east-west is approximately 4000 kilometers
Bunny OS 4000 is a series of operating systems made by Horatiu. There is Bunny OS 4000 SP1 Bunny OS 4000 SP2 Bunny OS 4000 SP3 Bunny OS 4000 SP4 And current Beta testing of Bunny OS SP5.
To find the resistance of the circuit, you can use Ohm's Law, which states that ( R = \frac{V}{I} ), where ( R ) is resistance, ( V ) is voltage, and ( I ) is current. Given that the current ( I ) is 0.0030 A and the voltage ( V ) is 12 V, the resistance ( R ) can be calculated as follows: [ R = \frac{12 , \text{V}}{0.0030 , \text{A}} = 4000 , \Omega. ] Thus, the resistance of the circuit is 4000 ohms (or 4 kΩ).
if you get 11 dollars per lb and car is 4000 lbs how much will i get
CT ratio is the ratio of primary (input) current to secondary (output) current. A CT with a listed ratio of 4000:1 would provide 1A of output current, when the primary current was 4000A.
Brian Walsh and Esdras Accime are tied for it
Pay scale 10050 & Grade Pay 2400
4000% of 4000 =4000/100 * 4000 =160,000