i. For measurements, display
and control of current, voltage, temperature, pressure, etc.
ii. For traffic
control and industrial tool control.
iii. For speed control of machines.
hardware design and implementation. The exact same as the application of a microprocessor. Many modern, high power digital systems are centered around a microprocessor.
Hookup drawings in instrumentation require several key inputs including the process flow diagram (PFD), equipment specifications, and instrumentation data sheets. Additionally, information on the control logic, wiring diagrams, and specific installation details such as signal types and connection points are essential. Understanding the functional requirements of the system and communication protocols also aids in accurately depicting the connections and interactions among instruments. Finally, any relevant industry standards or codes should be considered to ensure compliance.
High Common Mode Rejection Ratio is the main feature of instrumentation amplifier! And other features are high input impedance, low output impedance, high slew rate, low power consumption, more accurate, easier gain adjustment, low thermal and time drift.
basically an input is given to the transducer, which is the 1st basic block of instrumentation system. this transducer's o/p goes to the signal conditioning circuit whose o/p is then given to the recorder, analog meter, digital transistor, printer, controller, oscilloscope and the punch card.
System Application and Products in Data processing. It's an ERP Software.
Industrial , Commerical and Domestic.
Decoders are used to analyze data streams for a certain data code and give an output if the data is present like an address to a peripheral unit that needs service. application of decoders as follow microprocessor memory system microprocessor input-output system memory chip microprocessor instruction chip & lots of other application
comuter which uses microprocessors for control task that is the microprocessor based computer system........
Transducer & Sensors Electronics & Measurement Microcontroller Embedded System Control System process control industrial instrumentation
On the motherboard
advanced microprocessor ignition system is the one which uses it.........thats all i know...........
Instrumentation engineering is the specialization in principal and operation of measuring instrument which is used in designing and configuration of system.
microprocessor
a microprocessor is a small unit with memory inside the system unit while a computer is the combination of a monitor and a system unit
mainlyelectronics and instrumentation deals with the electronics based instruments and process controlling of those connected to a process e.g : plc dcs and scada but instrumentation and control are concerned with the control system and the process loop modelling e.g: power drives , linear and non linear control system
The advantages of downloading the main program into a microprocessor based system can be it can cause the system to run efficiently and the main program will be able to be easily accessed through the microprocessor system. Disadvantages can be due to errors they can happen due to system failure.
electronics and instrumentation engineering it deal with measurement and control system with electronic base,it is all most same as ece