no you can not it would ruin your system for good. You have to get a heaters with the same watts
Typically, use 5 * the volume in cubic feet to get BTU/hour for natural gas heaters. For this shop, that works out to 180,000 BTU/hr. Lower ceilings would make a big difference here...
You do not mention how much you want to heat the water and in what period of time. But here are the figures: 1 btu = temperature increase of 1* F of 1 pound of water. One gallon of water weighs 8.33 lbs. So a boiler with an output rating of 2,332,400 btu will raise the temperature 1*F in 1 hour. (280,000x 8.33). Boiler outputs are rated in btu per hour . how many btu does it take to heat 15lb of water from 100 degrees F to 129 degrees F?
If measuring heat, a BTU measures the amount of heat that is required to raise the temperature of a pound of water to 1º Fahrenheit. In terms of air conditioning, the BTU determines the amount of heat the unit can remove from the room. As the BTU rating increases, so does the size, weight and cost of the unit.
Rough estimate is that one btu is enough energy to change the temperature of one pint of water, one degree over a period of one hour.
17574
The top of the line residential on demand water heaters can run between 7 and 9 gallons per minute at 199,900 BTU. All water heaters perform roughly the same job-- they raise the incoming water approximately 30 degrees C at a rate sufficient to support at minimum 2.5 gallons of water being used per minute. This is about 16,600 BTU.
60000
The BTU output requirements of your furnace must be determined by heat load and heat loss calculations on the area that is heated. You should consult several HVAC contractors for estimates and recommendations.There are many factors that influence the BTU requirements of a furnace in any location.
About 0.43 US gallons of oil.
Natural-gas spa heaters are the best for rapid and energy-efficient water heating. Sta-Rite and Hayward are the leading brands for these types of heaters. Look for high BTU output (for rapid heating) and a corrosion-free stainless steel burner.
the amount used with vary with different models of propane heaters, the volume of water being heated, and the amount of hot water used by the household.. the answer is not definative, but you might be able to get a rough idea by "googling" the manufacturer...
The size is determined by the ac contractor or engineer.
read the pool heaters manual.
You can try the Master TC102, Propane Portable Convection Heater, 25,000 btu
1 BTU is required to raise 1lb of water 1 degree F in 1 hour. 212-75=137 degrees 600 lbs water x 137 degrees= 82,200 BTU's required to change 75 degree water to 212 degree water. To change 212 degree water to 212 degree steam it requires 970 btu's (latent heat of vaporization) per lb of water 970 btu x 600 lbs water = 582,000 btu Answer - 582,000 btu+ 82,200 btu = 664,200 btu's
When you compare the cost of propane and electricity, the cost of propane is lower than that of electricity. This is because whereas propane is a primary source, electricity is a secondary source.