A diode typically has low resistance for current in one direction, and high resistance
for current in the other direction. This is not really the description of anything that
could be called a 'switch'.
if a diode is in forward biased the diode acts as switch is on and when we apply the diode in reverse biased then it work as the switch as off.
a diode in a ckt basically acts like a switch!! it acts like a switch in on position i.e a short when forward biased and acts like a open ckt or a swich in off position when it is reversed biased!! its used inanalog circuits to generate different types of waves.........
Allows 1 way current/voltage flow
uni junction transistor
When p-n junction of a diode reversed biased then majority carriers are not able to cross the junction and are attracted in respective regions.So current becomes approximately zero.But because of minority carriers a reverse current keeps flowing.It is called Reverse Saturation Current.And due to attraction towards sides,charges go away from junction.So width of depletion reason increases.
A zener diode cannot be used as switch.
if a diode is in forward biased the diode acts as switch is on and when we apply the diode in reverse biased then it work as the switch as off.
A diode is voltage and current sensitive it follows an exponential curve and lower then .6v it is considered off and above .6v is considered on.
When the diode is reversed biased (positive charge applied to the N side and the negative charge applied to the P side) no current can flow just like when a switch is off. When the diode is forward biased (positive charge applied to the P side and the negative charge applied to the N side) no current can flow just like when a switch is on. Current can only flow in one direction.
a diode in a ckt basically acts like a switch!! it acts like a switch in on position i.e a short when forward biased and acts like a open ckt or a swich in off position when it is reversed biased!! its used inanalog circuits to generate different types of waves.........
No, a diode can rectify an AC signal but is not able to amplify an AC signal. Diodes are two layer devices whereas transistors have three. It is this very thin 'base' region in the transistor that gives it the ability to give a voltage or current gain.
acts like a normal diode in forward biased condition
a diode and it has a constant voltage across it ANSWER: acts as a voltage regulator if enough current flows to create a breakdown voltage.
I think there is no difference between PNPN diode and NPNP because if u look at the basic structure of this diode from anode side it is a PNPN diode and if u look at it from the cathode side it is a NPNP diode.......actually it is a four layer silicon device with two terminals...it consists of 3 junctions..it acts as a switch during forward bias condition..... i hope it's the correct one....if I am wrong please post the correct answer so that i can correct myself.....
when a semiconductor is doped with p-type and n-type impurities, a pn junction is formed which acts as a diode and prevents the charge carriers to flow to either side of junctionpn juction diode is a semiconductor device that allows current to flow only to one direction.
bad fuse , bad electrical connection to or bad switch ( back up light switch on manual transmission / neutral safety switch on automatic transmission also acts as backup light switch )
In OA79, the letter A stands for rectifier diode and O stands for Germanium. It acts as a point contact germanium diode and also be replaced with 1N4148 depending on the circuit.