answersLogoWhite

0

No. An AC switch cannot break the arc that occurs when you try to open the DC circuit. In an AC circuit the switch just handles the arc for a short period of time until the voltage reverses.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What ingredients may be unavailable due to the limitations of ancient trade?

Sugar was unavailable so the Sumerians used Honey.


What is the Difference between will be unavailable and will not be available. which on is correct?

Both "will be unavailable" and "will not be available" essentially convey the same meaning that something will not be accessible in the future. Both are correct and can be used interchangeably.


Which voltage is applied to the paper to transfer the toner to the paper in an ep process laser printer?

A high voltage, typically around 600 to 1000 volts, is applied to the paper in an electrophotographic (EP) process laser printer to transfer the toner from the drum to the paper. This electrostatic charge helps the toner particles adhere to the paper before being fused in place by heat.


Why is most of the worlds fresh water is unavailable to be used?

That is because most of it is in galsures.


What is an on and off switch used for?

It is used to switch equipment on and also it can be used to switch it off at a later time.


What is the difference between unavailable and occupied delta?

Unavailable delta refers to a situation where a resource is not accessible or out of reach, while occupied delta means that the resource is currently being used or taken up by something else.


What are the processor and switch used in the WNR834B?

What are the processor and switch used in the WNR834B


Why is childrens Benadryl currently unavailable?

because to many parents used it to lube wile raping their children.


What type of switch memory is used to store the configuration used by the switch when the switch first comes up?

ram


What is a managed switch used for?

A managed switch is a network switch, which is used for connecting computers and network devices. It is handy because it allows you to handle individual ports of the switch.


Can a 3-way switch be used as a single pole switch?

No, a 3-way switch cannot be used as a single pole switch because they are designed for different wiring configurations and functions.


What is a Cisnco Catalyst 4948 switch used for?

This switch is used to switch between servers on networks and earth link systems. If you dont know which switch to use, the guide can help you depending on your needs.

Trending Questions
Is it true that pipes for a hot water heater need to be changed every five years? There is a 100 watt light left on for 30 days and uses 72 kilowatt-hours suppose thecost of this electricity is 5.76 how much electricity does a 100 watt light bulb use in one week what's the cost? How do you build a model windmill for a garden? What type of loop always execute at least once? Why is your consort ev265 power supply reading low current and power? What is the difference between trailable and non trailable point machine? What is the working principle of three phase servo motor? What is the difference between cost and benefits when referring to an environmental project? Write a srs for restaurant billing system? What do digital engineers do? What is the name for the peace of skin betwene the tumb and the pointer finger? What does SB stand for in piping material? How can we draw a flow chart to generate a multiplication table? What is difference between name and value in an HTML Form? What is The act of being responsible while working on a scientific investigation following directions wearing apron and goggles knowing the location of emergency equipment etc.? What contributions did the Roman Empire make in the following areas art architecture and engineering language writing philosophy and law? What would cause a sudden increase in electrical usage in a home with no added electric devices? Converting digital computer signals to audible analog tones is known as? What is the off load voltage of the generator? C programs using loops?