answersLogoWhite

0

What else can I help you with?

Related Questions

Which president had a jawbone made of rubber?

Grover Cleveland lost his jawbone to cancer and had it replaced with a piece of molded rubber.


If a copper wire in a working electric circuit is replaced by a piece of rubber tubing will there be a current in a circuit?

no rubber stops the flow of electricity


If a copper wire in a working electric circuit is replaced by a piece of rubber tubing will there be a current in the circuit?

No, a rubber tubing is an insulator and will not allow the flow of electric current like a conductor such as copper wire would. Therefore, if the copper wire is replaced by rubber tubing, the circuit will be broken and no current will flow.


Can you put rubber bands between your teeth without braces and still help them strate?

You probably can, but the rubber bands will break easily and will have to be replaced a lot.


What if your motor mounts are loose can they be tightened or be replaced?

The bonded rubber is probably ripped, replace them.


Can the rubber sleeve between the fuel filler neck and fuel tank be replaced?

Normally yes.


Would there still be a current if rubber tubing replaced a copper wire?

No, It would not still work because, Rubber isn't a conductor. Rubber is an insulator. Though if you put a copper wire there and put rubber around it there will still be a electrical current that flows through.


What will happen if the connecting wire is replaced by a rubber band in an electric circuit?

Taking the wire off will make a difference. Putting a rubber band on afterwards will make no difference.


How to change the rear quarter glass of a 1998 Honda Civic Sedan?

i got my rear corner glass replaced at the junkyard. all they did was remove the rubber sealant around the glass. then they unclipped the glass. they replaced the glass and put the rubber back on. it looked so easy that i could of done it.


What is the purpose of a toilet rubber flapper and how can it be replaced or repaired?

The purpose of a toilet rubber flapper is to control the flow of water from the tank to the bowl during flushing. It can be replaced or repaired by turning off the water supply, removing the old flapper, and installing a new one according to the manufacturer's instructions.


What causes a 5-speed to slip after in gear and smell like rubber burning?

The clutch is slipping and needs replaced.


How do you replace dash lights on a 1999 Toyota Camry?

Do I need rubber like caps on new replaced bulbs in the dash