Yes, but dont forget the pea trap.
typically shower drains are 2"
If you have a drain available. You may need to chip some concrete around the drain to install the bottom half of the drain. With that in place, set the shower over it and the top piece screws into the drain to form a seal. You can build a 2x4 frame and raise the shower up enough to run a drain to a sump or a floor drain.
2"
2"
You need at least a 3 in. pipe -- shower is 2 in. pipe
The rough in height for a vanity drain is typically around 18 inches above the finished floor level.
To prevent clogs in your shower drain, use a shower drain protector to catch hair and debris before they go down the drain. Regularly clean the protector to maintain proper drainage.
Shower drain goes into a trap under shower. Continue piping from trap to drain line.
Water won't drain from shower. Either trap or shower drain line is clogged.
A shower drain plumbing diagram typically includes the shower drain, trap, waste pipe, and vent pipe.
The recommended drain height for a vanity installation is typically around 18 inches above the finished floor level.
The recommended height for a vanity drain installation is typically around 18 inches above the finished floor level.
The recommended rough-in height for a vanity drain is typically around 18 inches above the finished floor level.
To change a shower drain cover, you can typically unscrew the existing cover using a screwdriver or pliers. Once the screws are removed, lift the old cover out and replace it with a new one by screwing it back in place. Make sure the new cover fits securely and is properly aligned with the drain opening.
An offset drain shower pan allows for more flexibility in the placement of the shower fixtures and can provide better drainage. This design can also create a more spacious and visually appealing shower area compared to a traditional centered drain shower pan.
The standard size of a shower drain is typically 2 inches in diameter.
To change the shower drain cover, you can start by removing the screws holding the current cover in place. Once the screws are removed, lift the old cover out of the drain. Then, place the new cover over the drain opening and secure it in place by tightening the screws. Make sure the new cover fits properly and is securely fastened to prevent any leaks.