Yes, just use L1 and L2 ( just 2 of the 3 legs), or one of the legs to a neutral wire if equipped. Just make sure the voltage is the same as the 220 volts you wish to have with single phase service.
single phase, double phase & three phase
The difference between a single phase and a three phase motor is the amount of power conductors that feed the device. As to the other part of the question a three phase motor will not start or run on single phase. The phase angles on three phase are 120 degrees apart on a single phase system they are 180 degrees apart.
Yes, there a difference between three phase and single phase electrical supply services.
A three-phase meter can be used for single phase while the reverse is not the case.
3 phase /sqrt(3) * 30 degree phase shift = single phase.
To use a single/one phase motor instead of a three phase motor is possible if you have a three phase power supply as you will only need to tap one of the three phases together with neutral and an earthwire, however to use a three phase motor instead of a single phase will require the provision of three phase power supply.
The formula you are looking for is I = W/E. I = 746/220 = 3.39 amps <<>> Rule of thumb Current (Amps) of Single phase 240Vac motors = HP x 5 For Single phase 220Vac use Rule of Thumb and add 0.5A Current (Amps) of three phase 400Vac motors = HP x 1.5 Good for single phase from fractional HP values up to 7.5 HP. Good for three phase HP values up to 30 HP
Yes, there is a difference between single phase and three phase circuits.
There is no such thing as a two phase instrument. There is only single phase and three phase. You can only have: single phase/ one pole single phase/ two pole three phase/ three pole
single phase, double phase & three phase
Residential step-down transformers (xxxx to 120volts). Usually a single phase transformer will be used, and connected to one (or possibly two, depending on configuration) of the three phase conductors on the primary side.
No A intermediate switch can not be used to change three phase to single phase.
Single phase.
The difference between a single phase and a three phase motor is the amount of power conductors that feed the device. As to the other part of the question a three phase motor will not start or run on single phase. The phase angles on three phase are 120 degrees apart on a single phase system they are 180 degrees apart.
Single phase inherently requires less equipment (it's cheaper). Three phase motors are more efficient than single phase.
Yes, there a difference between three phase and single phase electrical supply services.
A three-phase meter can be used for single phase while the reverse is not the case.