No. The large farad capacitors are not designed to pass a lot of current. They are intended for ultra-low current applications such as memory retention in a CMOS type device.
micro farad
To wire a Tsunami 5 farad capacitor, first ensure that the vehicle's power is off. Connect the positive terminal of the capacitor to the positive terminal of the battery and the negative terminal to the vehicle's ground. Use appropriate gauge wire for the connections, and install a fuse in line with the positive lead to protect against short circuits. Finally, make sure to charge the capacitor before connecting it to the audio system to avoid damage.
I Rather not think that you can buy 2 farad capacitor and no the terminals must follow polarity guidelines.
The unit of capacitor is farad. 1 farad =10 to the power of 6 microfarad and also = 10 to the power of 12 picofarad Therfore if you are replacing one picofarad capcitor into one microfarad capacitor you are increasing the capcitance to 1000000 times. If it is in an oscillator circuit you are changing the frequency drastically which will be of no use.
Only electrolytic capacitors (tantalum capacitors are a type of electrolytic capacitor) are polarized.0.001 farad = 1000 microfaradThis is a value that is too large for any practical capacitor except an electrolytic, so yes it will be polarized.
about 500 uF
Farad is the basic unit for capacitance. The MFD is an abbreviation for microfarad, which is one-millionth of a farad. The capacitance of a 50 MFD capacitor is one 50 millionth of a farad.
micro farad
To wire a Tsunami 5 farad capacitor, first ensure that the vehicle's power is off. Connect the positive terminal of the capacitor to the positive terminal of the battery and the negative terminal to the vehicle's ground. Use appropriate gauge wire for the connections, and install a fuse in line with the positive lead to protect against short circuits. Finally, make sure to charge the capacitor before connecting it to the audio system to avoid damage.
The SI unit of capacitance is the farad. 1 farad is 1 coulomb per volt.
The Farad is a measure of how much electric charge is accumulated on the capacitor. Named after Michael Faraday
I Rather not think that you can buy 2 farad capacitor and no the terminals must follow polarity guidelines.
When used in car audio applications, a 1 farad capacitor is usually about 6" long and about 2.5-3" in diameter.
The unit of capacitor is farad. 1 farad =10 to the power of 6 microfarad and also = 10 to the power of 12 picofarad Therfore if you are replacing one picofarad capcitor into one microfarad capacitor you are increasing the capcitance to 1000000 times. If it is in an oscillator circuit you are changing the frequency drastically which will be of no use.
It takes 1 farad for every 1000 watts so u need 2 farads.
500K is 500 000 µ Farad so it's ½ a Farad
The capacitor will not cause dimming, whatever it is that the capacitor is being used for (usually helping drive a bass amp) is what causes the dimming. A capacitor is a quick charge and quick discharge battery basically, so when the amp has depleted the power in the cap it still must go to the car battery for power and that is when there will be dimming lights.