A potentiometer is a variable resistor, while a voltmeter is a device that measures voltage.
A voltmeter is used to read voltage values. A potentiometer is used to vary voltage values.
Copper is not used in potentiometer due to the following reasons: 1)Low resistivity 2) High Temperature Coefficient of resistance
because voltmeter is used to measure the voltage
a voltmeter is used to measure voltage
A voltmeter is used to measure potential difference across two points in an electrical circuit . The voltmeter is connected in parallel across the circuit element (resistance ) so that its inclusion in the circuit has negligible effect on total resistance and current flowing in yhe circuit A voltmeter has high resistance,if connected in series it will increase of circuit and reduce the current in the circuit
it tastes sweeter and has less calories than glucose
A voltmeter is used to measure voltage. A potentiometer is used to vary the amount of resistance in a circuit - it has nothing to do with measuring.
An ammeter should not be used as a voltmeter. An ammeter is a low impedance device that measures the current going through a circuit, often by measuring the small voltage across a known resistance. A voltmeter is a high impedance device that measures the voltage across a circuit. If you were to connect an ammeter as if it were a voltmeter, you would effectively short out the circuit, drastically affecting its operation, and potentially damaging both the circuit and the ammeter.
you can, but you will not get accurate answer as voltmeter consumes some current. so, potentiometer is used instead to measure emf ---- the potentiometer must be set to the expected emf from the cell before you put the zero detector in circuit if its set too high it will charge the cell too low it will load the cell perhaps if you dont know the voltage of the cell before you measure it you should get a hi impedance voltmeter(electrometer) to set the potentiometer as close as you can manage before you connect the zero detector
A potentiometer is a variable resistor used in electronics.
A: The only calibration that a potentiometer is allow to do is on the resistance scale. The reason being is the internal battery looses capability with age so to compensate the pot. will change current available to make the ohmmeter to go to zero when the probes are shorted. To test a volts range then an accurate voltage must be used to verify calibration.
Yes.
It is a potentiometer.
Copper is not used in potentiometer due to the following reasons: 1)Low resistivity 2) High Temperature Coefficient of resistance
the purpose of a voltmeter is used to measure voltage in a circuit
A voltmeter is a measuring instrument that is used in the measurement of the electric potential in volts.
why is extention
An electrical potentiometer that can be used to measure joint angles.