you can, but you will not get accurate answer as voltmeter consumes some current. so, potentiometer is used instead to measure emf
---- the potentiometer must be set to the expected emf from the cell before you put the zero detector in circuit if its set too high it will charge the cell too low it will load the cell
perhaps if you dont know the voltage of the cell before you measure it you should get a hi impedance voltmeter(electrometer) to set the potentiometer as close as you can manage before you connect the zero detector
Bcoz the emf which is to be measured is less than emf of driving cell....
When we place a current carrying conductor in a magnetic field emf is induced in a coil. we can knoe it by connecting voltmeter.
V which abbreviates the word volt, which is the unit of measure of the difference in electromotive force (EMF), (or electric potential) between two points of contact; the resulting voltage difference could be direct current (DC) or alternating current (AC) depending on the source of the voltage difference.
When a technician uses a voltmeter he or she can measure the power going through a circuit. It can test the safety and reliability of a an appliance also.Another AnswerA voltmeter is used to measure the potential difference, or voltage, between conductors. To measure power (as mentioned in the original answer) you need a wattmeter, not a voltmeter.
The only reason anyone will put a voltmeter in series is to measure current flow as a function of voltage drop.
because voltmeter is used to measure the voltage
You can measure the emf of a cell by using a voltmeter, as this draws current from a cell. You can use the voltage, the emf, and the load resistance to determine the internal resistance of the cell.
Use a voltmeter.
"voltmeter"
To measure the total emf simply connect the battery and voltmeter with the right terminals , but to measure the terminal potential difference which is less than the emf the voltmeter is connected in parallel with the battery
A voltmeter is used to measure voltage. A potentiometer is used to vary the amount of resistance in a circuit - it has nothing to do with measuring.
Voltmeter is a device to measure EMF and potential difference in terms of volts Thermometer is a device to measure the temperature in terms of K(kelvin),C(Celsius) F(Fahrenheit)
EMF (E''electromotive Force'') is another term for Volts, hence the E in electronic formulas and EMF is measured with a volt meter. A potentiometer is not a meter at all, it is a variable resistor
Bcoz the emf which is to be measured is less than emf of driving cell....
When we place a current carrying conductor in a magnetic field emf is induced in a coil. we can knoe it by connecting voltmeter.
It is a voltmeter which can only measure direct current.
A voltmeter measures voltage in volts.