0
What else can I help you with?
What are examples of dynamic loads?
A Person walking on a bridge, wind, cars on a bridge. Basically anything that doesn't stay on that structure forever.
What is mandatory in bridge designs?
wind tunnels
What is the force exerted by the Tacoma narrows bridge?
the force was torsion. the wind made it bend like silly puddy ************** The force exerted TO the Tacoma narrows bridge was initially the wind resistance. The wind resistance caused the whole bridge to act as a system with forced vibration with damping.
Why are wind turbines so high?
To get the maximum amount of wind. If they were low to the ground the wind levels would not be so high.
Is there a high wind vent cap for a gas furnace roof vent?
Yes you can get a high wind cap for the vent.
Will the sagamore bridge close because of high wind?
Yes. If the wind gets over 70 miles an hour. Check with State Police.
How would high wind affect the forces acting on a bridge?
it just does. okay?
On a weather map high wind speeds are indicated where are spaced close together.?
On a weather map, high wind speeds are indicated where thin lines with arrows are spaced close together. This indicates strong winds and the direction in which they will move.
When was Donghai Bridge Wind Farm created?
Donghai Bridge Wind Farm was created in 2010.
Why is wind a major problem for suspension bridges?
High sided vehicles may be stopped from using a high suspension bridge during strong winds, in case the vehicle turns over. Also, there have been cases when a bridge has vibrated to a wind and started to sway from side to side, even to collapse in one or two extreme cases.
What caused the tacma narrows bridge to collapse?
Tacoma bridge fell down because it is too narrow compare to its length. So the bridge was unstable and due to strong wind it was collapsed.
What are examples of dynamic loads?
A Person walking on a bridge, wind, cars on a bridge. Basically anything that doesn't stay on that structure forever.
What is mandatory in bridge designs?
wind tunnels
What is the force exerted by the Tacoma narrows bridge?
the force was torsion. the wind made it bend like silly puddy ************** The force exerted TO the Tacoma narrows bridge was initially the wind resistance. The wind resistance caused the whole bridge to act as a system with forced vibration with damping.
What is an example of torsion?
A suspension bridge twisting in the wind.
A tourist drops a camera from 20meter high bridge what is the speed of the camera as it hits the water?
more information is needed, such as weight of the camers, shape of the camera, and the wind speed
Give a example of a suspension bridge that failed and explain the cause?
Tacoma Narrows Bridge in 1940. This bridge was the 3rd longest suspension bridge when it was completed. Four months after is was opened it collapsed due to wind. The wind created vibrations in the bridge as it blew across the roadway. The bridge normally experienced vertical wave-like movement until on Nov. 7, 1940 when the 42mph wind came and caused the bridge to start twisting in addition to the vertical motion. The entire center span fell into the sound below.
