Fusing currents is combining two or more wires together to join the currents. A critical factor is the temperature of the wire.
The higher the resistance the lower the current flow. It restricts the flow of electrical current. The resistance will not depend upon the current. The current flow will depend on the resistance.
1 sq..mm have max. capacity is 10 ampere if these are of copper approximately than 120 sq..mm having current carrying capacity is 1200 ampere
Pressure from the voltage.
Frequency doesn't depend on either voltage or current.
if your load draws a max of 15 amps then you would use 14-16 gauge wire. the lower the gauge the more current that is allowed to pass. there are charts that show max current for diameter of wire
that would depend on its fusing system.
Of an acre of what? Cropland? Pasture? Rangeland? Also where abouts are you referring to? All of these factors depend on what the carrying capacity if an acre is.
The factors on which the current through an electrolyte depend are: (i) Nature of electrolyte (ii) Concentration of the solution (iii) Temperature
no, because it is depend on its current carrying capacity. eg-if 25amp current flowing in the ckt then 30amp breaker don't protect the ckt but if it is cross the rated capacity then breaker works.
The higher the resistance the lower the current flow. It restricts the flow of electrical current. The resistance will not depend upon the current. The current flow will depend on the resistance.
Granting credit typically depends upon three factors: character of the borrower, capacity to repay, and capital used as collateral
1 sq..mm have max. capacity is 10 ampere if these are of copper approximately than 120 sq..mm having current carrying capacity is 1200 ampere
heat capacity
That would depend on the Hybrid.
No.
Protostars will eventually evolve into main sequence stars, where they will spend the majority of their lifetime fusing hydrogen into helium in their cores. The exact path of evolution will depend on factors such as mass, temperature, and composition.
There's no set capacity, it'll depend on the rating of that particular relay.