Voltage = Current x Resistance
giving us
Current = Voltage / Resistance
i.e. Voltage divided by resistance
One way to determine current is to measure it, with an ammeter. Another way is to calculate it using Ohm's law: current = voltage / resistance.
There is insufficient information in the question to properly answer it. You need to specify, also, the voltage, in order to determine resistance from current. Please restate the question. Ohm's Law: Resistance = voltage divided by current.
A: Checking continuity is the same as checking resistance, therefore yes someone can determine the resistance at that particular current level
A multimeter device can measure resistance, current, AC/DC voltage, and it also can determine continuity on an electrical circuit, and its range for current, voltage and resistance is widely variable.
V = I * R or I = ( V / R ) I = current (amps) V = Voltage R = Resistance The current in a circuit depends on the applied voltage and the resistance of the circuit.
To find resistance from a graph of voltage vs. current, you can calculate the slope of the graph. Resistance is equal to the slope, so you can divide the voltage by the current to determine the resistance. The unit of resistance is ohms (Ω).
-determine the direction and value of current -determine the potential difference -determine the value of resistance
One way to determine current is to measure it, with an ammeter. Another way is to calculate it using Ohm's law: current = voltage / resistance.
You use an ohmeter. It sends current through the wire to determine value.
You can measure the emf of a cell by using a voltmeter, as this draws current from a cell. You can use the voltage, the emf, and the load resistance to determine the internal resistance of the cell.
There is insufficient information in the question to properly answer it. You need to specify, also, the voltage, in order to determine resistance from current. Please restate the question. Ohm's Law: Resistance = voltage divided by current.
To determine the current in the top wire, you need to know the voltage and resistance of the circuit. Use Ohm's Law (V IR) to calculate the current, where V is the voltage and R is the resistance.
A: Checking continuity is the same as checking resistance, therefore yes someone can determine the resistance at that particular current level
Resistance is measured in ohms and the amount of resistance that allows one ampere of current to flow when one volt is applied is one ohm.
The current in amps (A) depends on the resistance in the circuit. Using Ohm's Law (I = V/R), you can calculate the current (I) by dividing the voltage (V) by the resistance (R). Without knowing the resistance in the circuit, we cannot determine the exact current at 320V.
A multimeter device can measure resistance, current, AC/DC voltage, and it also can determine continuity on an electrical circuit, and its range for current, voltage and resistance is widely variable.
to determine the comparison of resistance value of both forward and reverse diode . The more the resistance the lower the current , the lower the resistance the higher the current . When reverse bias , the resistance is high and it acts in open circuit and the reverse current is very small that can be neglected . When forward bias , the resistance is low and it acts as short circuit and the forward current is increasing as the voltage supply is higher .