answersLogoWhite

0

If a nut is very likely to be tough, or if it's rusted in place, I heat it with a propane torch first. If applying heat is dangerous, I hit one flange of the nut with a spring loaded impact tool.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What is an anchor nut?

An anchor nut is a nut designed not to require a wrench for tightening and loosening.


How to loosen a 2000 buick lesabre belt tensioner?

Use a wrench and place it on the large nut. Push the wrench like you are loosening the nut. The tensioner will rotate and remove pressure from your belt.


What is the best way to use an under sink faucet wrench for tightening or loosening a faucet?

To use an under sink faucet wrench for tightening or loosening a faucet, first locate the nut that needs to be adjusted. Insert the wrench into the tight space under the sink and position it securely on the nut. Turn the wrench clockwise to tighten the nut or counterclockwise to loosen it. Be sure to apply steady pressure and avoid over-tightening to prevent damage to the faucet.


What is purpose of the open end wrench?

Do up or undo a nut where a ring wrench or socket might otherwise not fit.


What is the proper way to use a double-ended crescent wrench for tightening or loosening bolts and nuts?

To use a double-ended crescent wrench for tightening or loosening bolts and nuts, select the appropriate size of the wrench that fits the bolt or nut. Place the open end of the wrench onto the bolt or nut and turn it clockwise to tighten or counterclockwise to loosen. Make sure the wrench is securely in place before applying force to avoid slipping and causing damage.


What is the best way to use an under sink wrench for tightening or loosening plumbing fixtures?

The best way to use an under sink wrench for tightening or loosening plumbing fixtures is to position the wrench around the fixture's nut and turn it in the desired direction. Make sure to apply steady pressure and use the appropriate size of the wrench to avoid damaging the fixture.


When should you push and pull on a wrench?

Push on a wrench when loosening a fastener as this adds force to break it free. Pull on a wrench when tightening a fastener to apply force in the correct direction. Remember to use the correct technique to avoid injury.


How do you loosen the fuel lines on your 2000 Blazer?

The only reason there is problem in loosening the fuel lines is the wrong wrench is being used, which can slip on the fittings. A flare nut wrench should be used and these are then easy to properly loosen and tighten.


How do you loosen the tensioner on 2002 Chevy Silverado?

if by "loosen" you mean loosening the belt then just put a wrench on the nut in the center of the pulley and turn it to the left. its basically spring loaded.


What is a wrench?

A wrench is a tool used to turn a bolt or nut.


What size wrench fits a 35mm nut?

A 35mm wrench....


What size wrench for a 1.00-14 nut?

A 14 mm wrench.