Due to its inductive reactance (its opposition to a.c. current).
To limit the current through the lamp when the gas ionises and conducts.
no, in an ac circuit the coil provides impedance but the DC coil needs some resistance to limit the current
the quality factor for choke coil is impedence divided by resistance in a given circuit
These terms apply to the coils inside a wattmeter. 'Pressure coil' is an archaic term for 'voltage coil', which is connected in parallel with the supply, while the 'current coil' is connected in series with the load.
The choke enriches the mixture for start-up and then is heated by a small electrical heating coil so the choke goes off when the engine is at operating temperature.
To limit the current through the lamp when the gas ionises and conducts.
A choke coil is an inductor, which is designed to block a particular frequency in an electrical circuit while passing signals of very less frequency or direct current.
An ideal choke coil has only inductance. It has zero resistance and no stray capacitance, therefore no resonances.
fluorescent lamp work on the principle of ionizing the gas , which requires very high potential difference . this excess voltage is provided by the choke coil . when the starter breaks the circuit , current suddenly drops , thus to maintain the current the choke coil a very high voltage is supplied by the choke coil . this very high voltage cannot be obtained from a resistor or a rheostat , since it being a linear element , thus it cannot be a replacement for choke.
no, in an ac circuit the coil provides impedance but the DC coil needs some resistance to limit the current
the quality factor for choke coil is impedence divided by resistance in a given circuit
Choke coils have a piece of wire wrapped around an iron core and their purpose is to allow a low frequency (typically 60 Hz) to pass, while blocking higher frequencies. Choke coils provide electronic circuits with protection from fast events (like a lightning or similar discharge on the power wires) by acting as a shunt to events whose frequencies are above the intended range.
inductance and resistance are the parameters of the choke cil
nebonda
choke coils are various depend upon the specifications it built....for example if u take 0-5 amp choke coil it is used in household applications like for florescent lamps....
These terms apply to the coils inside a wattmeter. 'Pressure coil' is an archaic term for 'voltage coil', which is connected in parallel with the supply, while the 'current coil' is connected in series with the load.
Current coil carries the current.