answersLogoWhite

0

To connect two DDR SDRAMs with an FPGA, you typically use a memory controller implemented in the FPGA to manage the read and write operations. The FPGA's I/O pins are then connected to the corresponding data, address, and control lines of both DDR SDRAMs. Proper termination and impedance matching are essential to ensure signal integrity. Additionally, the FPGA's design must include timing constraints to synchronize access to both memory modules effectively.

User Avatar

AnswerBot

1mo ago

What else can I help you with?

Continue Learning about Engineering

What is the difference between plc and fpga?

fpga and plc are two completely different things. FPGA( field programmable gate arrays) are building blocks of electronic sysytem where as plc are systems. Comparing these two is like comparing engine with car.


What happens if you connect two transistors parallel?

If you connect two transistors parallel it will heat up and be damaged.


How do you connect Two DC generators together to double the output voltage?

You would connect them in series to double the output voltage.


How do you implement xor gate using multiplexer only?

Assume that the two inputs of the XOR gate are I1 and I2, and that the two inputs of the multiplexer are M1 and M2 and the selection line is S: Connect I1 to M1 Connect Not(I1) to M2 Connect I2 to S


How to connect 4 - 6V batteries for -12V system?

In order to connect 4-6 volt batteries and end up with 12volts you will need to understand parallel and series connections. to connect two batteries in parallel you would connect the positive side of one battery to the positive side of the other battery; and the negative side of one battery to the negative of the other battery. doing this will not change the voltage. to connect in series you connect the positive of one battery to the negative of the other battery. doing this will increase the voltage;in this example you will end up with 12v. 6+6=12. when you stack batteries in a 2-cell flashlight that is connecting the batteries in series. The answer to the question is: connect two batteries in series; then connect the other two batteries in series. after this is done connect the two pairs of batteries in parallel. If you think of it visually you would have two batteries wide and two batteries tall.

Related Questions

What is the difference between plc and fpga?

fpga and plc are two completely different things. FPGA( field programmable gate arrays) are building blocks of electronic sysytem where as plc are systems. Comparing these two is like comparing engine with car.


Is ddr computer ram for nokebook computer or we can use in desktop computer?

There is two types. There is DDR notebook RAM and there is DDR desktop ram. They can't be used vin each other (notebook RAM can't be used in a desktop) unless (in rare circumstances) you happen to have a notebook ram port on your desktop's motherboard. But no, DDR is a technology. Both desktops and notebooks support this technology because there is notebook DDR and desktop DDR. but notebook DDR can't be put in desktop DDR and vice versa.


What are two types of RAm?

DDR which is old and DDR2 is the most widely used. The DDR stands for Double Data Rate. DDR3 is next.


What are the two main types of ram memory sram and dram?

DDR and DDR2


How can we differentiate between an SDRAM and DDR RAM outwardly?

DDR Memory modules have only one notch on the contact strip, positioned just off-centre. Hence DDR modules will not fit in an SD slot. SD Memory Modules have two notches.


Will a DDR SDRAM module fit in an SDR SDRAM slot?

While I'm sure a destructive lunatic could force a DDR module into an older slot, they are not designed to be physically compatible. DDR modules have only a single notch, while SDR modules and slots are keyed with two notches and ridges.


Which type of computer memory module has 168 pins?

DDR


Does dance dance revolution take two dance pads?

You can use 1 if you want but if your doing ddr with two people then you need 2 mats.


Can you connect wireless modem to a switch which will connect to two routers?

can you connect wireless modem to a switch which will to two routers


Motherboard installing four 1GB DDR memory finding out two are PC3200 and other PC2700 will this mix hurt?

No. its alright.


Is it possible to connect two Excel workbooks connect data from one to another?

Is it possible to connect two excel workbooks connect data from one to another?


Where does 2 bones connect?

where does two bones connect