answersLogoWhite

0

If you mean IC or computer chips, there are a number of things to try. Integrating more parts can in some cases cut pin count as it can eliminate large buses between certain components.

Another idea would be to convert the signals to serial signals and create devices for the other end which also make use of the serial format. So then you may end up with only 3-5 traces between the parts.

User Avatar

Wiki User

11y ago

What else can I help you with?

Continue Learning about Engineering

How does ic cd4017be work?

The CD4017BE is a decade counter integrated circuit that counts from 0 to 9 and then resets to 0. It has ten output pins, each corresponding to a count state, and activates one output at a time in sequence with each clock pulse received at its input (pin 14). The IC can be used in various applications, such as LED chasers and frequency dividers, and features an enable pin to control counting operation. Additionally, it has a carry-out pin (pin 11) that generates a signal when the count reaches 10, allowing for cascading with other counters.


What is pin support?

Pin supports consist of a pin through 2 components which allows rotation about the joint but no translation relative to the pin due to the reactive forces from the pin preventing this movement.


Which device would use a 25-pin connector a 50-pin connector a 68-pin connector an 80-pin connector?

68


Why was the safety pin invented?

The safety pin was invented to pay off a debt.


What is the PIN of 3 input OR gate?

The PIN (Pin Identification Number) of a 3-input OR gate typically refers to the specific pin configuration for that gate in a circuit or on an integrated circuit (IC) package. For a standard 3-input OR gate, it usually has three input pins and one output pin. The exact pin configuration can vary depending on the manufacturer and the specific IC, so it's important to refer to the datasheet for that component for accurate pin assignments. In general, the output pin will be labeled as 'Y' or similar, while the input pins are labeled as 'A', 'B', and 'C'.