it works like this the 1.21 giggawatts of electricity that is generated by the plutonium that has been put into the back port of the de lorean is generated into the other electrically materialized parts and there it is
i) leakage flux is those flux which goes through the air and linkage flux is those flux whose go through the cell. ii)leakage flux is the loss at flux but linkage flu is warning flux. iii)leakage flux is cause of eddy current loss and linkage flux is case of copper loss.
light speeeed mofos
Basically useful fluke is the flux that flows with in the magnetic circuit of an armature. That is why when there is an air gap the flux enters the armature which makes it useful flux! Hope that answers your question!
A: The pad is not clean it has tarnish or wrong solder with not enough soldering flux. Finally not enough heat.
Flux is produced in both AC and DC systems, but the nature of the flux differs. In DC circuits, the magnetic flux is constant, as the current flows in one direction. In AC circuits, the magnetic flux changes direction and magnitude periodically, resulting in a time-varying magnetic field. Thus, while both types of current can produce flux, AC generates a dynamic flux due to its oscillating nature.
The flux capacitor is now only a phantasy. Flux capacitor will not work with Uranium. It has to be Plutonium.
No, it only works "in the movies".
i) leakage flux is those flux which goes through the air and linkage flux is those flux whose go through the cell. ii)leakage flux is the loss at flux but linkage flu is warning flux. iii)leakage flux is cause of eddy current loss and linkage flux is case of copper loss.
The Ratio of the total flux ( flux in iron path) to the useful flux (flux in air gap)
when a current flow through the coil then flux produced around the coil . if the flux linked same produced coil only then the flux is said to be leakage flux. flux produced by one coil ,but linked with another coil then the flu is said to be mutual flux.
when a current flow through the coil then flux produced around the coil . if the flux linked same produced coil only then the flux is said to be leakage flux. flux produced by one coil ,but linked with another coil then the flu is said to be mutual flux.
Flux gusto
Rosin flux will probably last hundreds or even thousands of years. I suspect that fossil amber would work as a decent flux. The solvent in liquid organic fluxes may evaporate, leaving a solid. Some paste fluxes are water based and the water will evaporate.
light speeeed mofos
Types of flux - Electric and Magnetic Flux. Electric field flux through a closed surface is equal to the change enclosed in the surface, or the rate of change of magnetic flux is equal to the induced voltage around the surface.
Flux is related to the speed of change in a physical quantity through the concept of flux density. Flux density is the amount of flux passing through a unit area per unit time. The faster the change in the physical quantity, the higher the flux density.
Yes, plumbers solder paste flux can be removed relatively easily, especially when it is still fresh. Using a damp cloth or sponge with warm water can effectively wipe away the flux. For dried flux, a combination of isopropyl alcohol or a commercial flux remover may be needed to fully clean the surface. Always make sure to rinse the area with water afterward to prevent any residue from affecting future work.