To match 2 phase line voltage it has to be the same voltage.
If both the voltages do not match then there will be current fllow from higher voltage to low voltge, this is loss of power and can lead to even tripping of the system.
No, the charging voltage needs to closely match the battery or BOOM!
To use an adapter of this sort, its rated voltage must match the rated voltage of the appliance, and its rated current must exceed that of the appliance. So, in your example, the rated voltage is too high to be used with your appliance.
It is mandatory to use a larger wire size to overcome voltage drop at the load.
To increase a kettle's efficiency, you can use a kettle that is the right size for your needs, regularly descale it to remove mineral buildup, and match the heat source to the kettle material. Additionally, keeping the kettle lid on while heating water and using an insulated kettle can help retain heat and improve efficiency.
No, the voltage from the adapter should match the voltage required by the appliance.
To match 2 phase line voltage it has to be the same voltage.
It depends where you bought it. In North America, its rated voltage will be 120 V whereas, in Europe, its rated voltage will be 230 V.
The measured voltage of a battery may not match the stated voltage due to internal resistance, temperature, or the age and condition of the battery. These factors can lead to voltage drops when the battery is in use.
yes "How to use a kettle" could be taken as a question, although not a particularly well composed question. A better phrasing would be, how do you use a kettle? Another way of asking this would be, I would like to find out how to use a kettle.
I would like to examine that kettle of fish.The kettle is black, I say!
Example sentence - I heated the water in the kettle to make tea.
The voltage for anything should match the supply voltage.
as long as the polarity and voltage match Get it wrong and you could Fry your PSP
if your looking for current (I) = voltage ./. resistance voltage (v) = current x resistance resistance (r) = voltage ./. current plug in your values calculate them then use meter to see if they match!
Yes it does. You just choose the correct size tip and voltage to match your Asus