0
How much concrete mix use in 5 cubic meter 1 bucket cement 4 bucket sand 8 bucket 40mm metal?
To calculate the total concrete mix for 5 cubic meters with the specified ratio of 1 bucket of cement, 4 buckets of sand, and 8 buckets of 40mm metal, first determine the total parts: 1 + 4 + 8 = 13 parts. For 5 cubic meters, each part would be approximately 0.385 cubic meters (5 / 13). Therefore, you would need about 0.385 cubic meters of cement, 1.54 cubic meters of sand, and 3.08 cubic meters of 40mm metal. Adjust bucket sizes accordingly to match these volumes based on the bucket's capacity.
What else can I help you with?
How do you remove bolt anchors from cement?
Normally you have to cut them off with a grinder. A grinder with a metal cutting blade will allow you to take them down flush with the concrete. Wear eye protection though it does throw lots of sparks and some concrete.
Why concrete is strong in compression and weak in tension?
Concrete is strong in compression, as the aggregate efficiently carries the compression load. However, it is weak in tension as the cement holding the aggregate in place can crack, allowing the structure to fail. Reinforced concrete solves these problems by adding metal reinforcing bars, glass fiber, or plastic fiber to carry tensile loads
How do you strengthen concrete?
you could strengthen it by putting metal bars inside the concrete
What holds concrete in place while it dries?
Concrete is held in place while it dries primarily by the use of formwork, which consists of molds made from wood, metal, or plastic that contain the wet concrete until it sets. Additionally, the chemical process of hydration, where water reacts with cement, helps the concrete gain strength and stability as it hardens. Reinforcement materials like rebar or wire mesh can also be included to provide added structural integrity.
Difference between ordinary Portland cement and puzzalona Portland cement?
OPC - Ordinary Portland cementOPC - Materials used - Argillaceous and calcareous materialsPPC - Portland Pozzolona CementPPC - OPC + Pozzolonoc materials(fly ash, volcanic ash, pumicite at the time of grinding).
What is the use of RCC?
RCC that is reinforced cement concrete which is composed of cement(mainly),sand(fine aggregate),metal(coarse aggregate)and water.Which is further more supported by iron which makes it RCC from ordinary cement concrete.
How do you calculate the amount of cement sand and blue-metal to lay 100 square feet reinforced cement concrete?
for 100sft or 100cft
Is concrete a metal nonmetal or metalloid?
Concrete is a mixture of materials including cement, aggregates (such as sand and gravel), and water. It is not classified as a metal, nonmetal, or metalloid, as it is a composite material with properties derived from its components.
What is a cement anchor?
A cement anchor is a general term to describe a fastner that is attached to concrete. Common concrete anchors have a lead tip that mushrooms and "grabs" the concrete. Usually a hole is first drilled into the concrete. Then a concrete anchor is driven into the hole using a hammer. This allows for attaching wood or metal to concrete.
What is the different between ordinary Portland cement and Portland cement?
Ordinary Portland cement is the most common cement used in the world, made from stucco, concrete, mortar and other materials. Slag cement is usually mixed with Portland cement and is the substance leftover after metal has been smelted from raw ore.
What is the process of calculating quantity of cement sand metal in concrete mix design?
Choose the grade of concrete & assume minimum water/cement ratio.Conduct some initial tests on the materials like cement, sand & metal(coarse aggregate).Tests like UNIT WEGHT, SPECIFIC GRAVITY,SIEVE ANALYSIS,SLUMP CONE TEST & COMPACTION FACTOR TEST. According to the obtained results do the mix design from IS CODE of IS800-10262 check for water cement ratio & calculate the quantity of cement, sand & coarse aggregate.
What can a metal bucket be made out of?
A metal bucket can be made out of materials such as galvanized steel, aluminum, or stainless steel. These materials provide durability and resistance to corrosion, making them suitable for various household and industrial purposes.
How do you remove bolt anchors from cement?
Normally you have to cut them off with a grinder. A grinder with a metal cutting blade will allow you to take them down flush with the concrete. Wear eye protection though it does throw lots of sparks and some concrete.
This hard rock is useful in building bridges and building what is it?
many have been used, but reinforced concrete is preferred now as properties are more predictable and consistent.
What is a kind of material that light can not go through?
Opaque materials, such as wood, metal, and concrete, do not allow light to pass through them because they absorb or reflect light instead of transmitting it.
How do you dissolve concrete?
Concrete can be dissolved using acid solutions like muriatic acid or hydrochloric acid. These acids react with the minerals in the concrete, breaking them down and dissolving the concrete. It's important to handle these acids with caution and to follow appropriate safety measures when attempting to dissolve concrete.
Is a bucket an insulator or conductor?
depends on the material the bucket is made of
