The cost to run an engine block heater typically ranges from $0.10 to $0.30 per hour, depending on the wattage of the heater and local electricity rates. Most block heaters are around 400 to 1,000 watts, so if you run it for 2-4 hours before starting your vehicle, the total cost would be approximately $0.20 to $1.20 per use. It's generally more economical to use the heater only when necessary, such as during extremely cold weather.
The weight of a 454 engine block, specifically the big block V8 engine commonly used in Chevrolet vehicles, typically ranges from about 600 to 700 pounds (272 to 318 kg) without accessories. This weight can vary depending on the specific design and any additional components attached to the engine.
His Steam Engine costed around £5000
Tankless water heater installation costs around $1200. But, they save money each year in energy costs, so, it is possible to recoup the money over time.
I was charged $464.00 and I thought that was a bit rich to replace a T&P Valve today 26/09/11
A tankless water heater is much more efficient as it "flash" heats the water.
$75 to $100 plus installation.
Usually much smaller. A normal freeze plug block heater is about fifty bucks.
About 1,800 dollars if you do it yourself.
A 350 is a small block, Not a big block. And you can buy that engine new from GM. for about $2000.00
2.0 marshal long block.............$2,529.79 2.5 marshal long block.............$2,584.79
The cost to install a block heater in a 1995 Ford Bronco typically ranges from $100 to $300, depending on the specific block heater model, labor rates in your area, and whether you choose to do it yourself or hire a mechanic. Parts can cost between $30 and $100, while labor can add an additional $50 to $200. It's advisable to check with local automotive shops for more precise estimates.
how much does the average gas home heater cost for a 3 bedroom single home?
$550-700 for a used engine at the boneyard. $2600 for a long block. $3500 for a new engine.
How much will it cost me to replace the heater core in my 1999 Mercury
It is used in extremely cold climates to aid in starting. The block heater keeps the fluids warm for a much faster start.
If the engine is an R2, RF or HW diesel engine, it would cost about USD 1,300. in the Philippines where i had my engine completely rebuilt, it cost me that much. what was not replaced was the engine block and the crankshaft only that required a USD 400 to reface. to buy a used one on an "as-is" basis, would cost almost the same plus the mechanic's fee that would be about USD 300.
It depends on what is broken on your water heater, as to how much it would cost to fix it. It might actually need to be replaced and be more cost effective to replace it.