0
What else can I help you with?
How much does it cost for sewer line cleaning?
For rodding up to 8" diameter it should cost $1.25 per foot of snake Min. Water Jetting $2.50 per ft
How much water is in sewer?
It depends how much back pitch there is
How much to dig up a 8' sewer line 10 feet down?
=== ===
How much does it cost to line a sewer pipe?
$2,300 per ft is the average for 8"
How much pitch on a sewer drain?
The pitch on a sewer drain, typically referred to as the drain slope, should generally be between 1% to 2% (or 1/8 to 1/4 inch per foot) to ensure proper flow and prevent clogs. This slope allows for efficient drainage by utilizing gravity to move wastewater through the pipes. Local building codes may specify exact requirements, so it's important to check those as well. Proper installation is crucial for maintaining the functionality and longevity of the drainage system.
How much slope for a 200' sewer run?
For a 200-foot sewer run, a common slope recommendation is 1% to 2% (or 1/8 inch to 1/4 inch per foot). This translates to a total drop of 2 to 4 inches over the entire length. The specific slope may vary based on local codes and the type of sewer system, so it's essential to consult local regulations for precise requirements.
How much is a Sewer bill?
$50
How much does it cost for sewer line cleaning?
For rodding up to 8" diameter it should cost $1.25 per foot of snake Min. Water Jetting $2.50 per ft
How much water is in sewer?
It depends how much back pitch there is
How much does it cost to have a sewer line cleaned?
$67.90
How much drop PER FOOT needed for 300' of pipe?
Drop per foot doesn't care about length of run, it depends on pipe size. Pipe larger than 2" needs only 1/8" per foot (37.5" fall for 300'), 2" and smaller needs 1/4" per foot (75" fall for 300')
2 percent grade is how much per foot?
2% grade is equal to a 1/4" per foot fall
Marcie bought a 50 foot role of packing tape. She used two 8 56 foot lengths. How much tape is left on the roll?
IF she just bought 50 feet then this would be too short for even one of her 56 foot requirements.
How much fence would you need to fence in a 15 foot by 18 foot rectangle area?
You'd need two lengths and two widths. That's 30-ft plus 36-ft, or 66-ft total. That's called the "perimeter" of the rectangle.
How much fall do you need for a 4 inch drain line?
2% (1/4" per foot) unless first approved by your plumbing inspector. If there is a lack of grade to allow for the fall you may be allowed to upsize the drain to 6" and run it at 1% (1/8" per foot)
How much does it cost to dig a sewer line for a new house?
$58,960
How much waste is put into the sewer each day?
over a million.
