Service call $175 ( min per hr) plus 10% mark up on materials
you unclog it
Plumbing pitch is the amount of fall you have on your waste. All waste, not on a pump system, has to have fall toward the destination of the waste (septic tank, sewer, etc.) The pitch is basically a downhill tilt of the pipe it requires to drain the liquid and solid waste from the pipe utilizing gravity. standard fall on a waste pipe is 1/8 of an inch per foot. the reasoning behind this is that your solid waste runs with your liquid waste minimizing clogs and optimizing drainage.
NO!
That depends on a number of factors that can only be addressed by a gas repair technician. -But call one soon, it may be dangerous !
Sleeving, or relining. It depends on the type of application.
No less then $1,800 normally
To effectively repair a drain pipe using a drain pipe repair sleeve, follow these steps: Clean and dry the damaged area of the drain pipe. Slide the repair sleeve over the damaged section of the pipe. Tighten the clamps on the sleeve to secure it in place. Test the repaired pipe to ensure there are no leaks.
Common methods used for sewage pipe repair include trenchless pipe lining, pipe bursting, spot repair, and traditional excavation and replacement.
Depends how it's broken, you don't explain much.
dvw pipe = drain, waste and vent pipe.
To effectively repair a galvanized pipe using a repair coupling, follow these steps: Turn off the water supply to the pipe. Cut out the damaged section of the pipe using a pipe cutter. Clean the cut ends of the pipe with a wire brush. Slide the repair coupling onto one end of the pipe. Slide the other end of the pipe into the other side of the repair coupling. Tighten the screws on the repair coupling to secure it in place. Turn the water supply back on and check for leaks.
Soil pipes and waste pipes differ in their purpose and the type of waste they handle. A soil pipe is designed to carry human waste and toilet paper from toilets to the sewer system or septic tank. A waste pipe, on the other hand, is designed to carry other types of waste, such as water from sinks, showers, and washing machines. Waste pipes can also carry food waste and other debris from garbage disposals. Additionally, waste pipes are typically smaller in diameter than soil pipes.
Waste water will run away too quickly to properly carry away any solids in drain pipe, eventually causing a clog.
If your bathtub pipe is leaking, it requires immediate repair.
If your shower pipe is leaking, it may need immediate repair.
To repair a PVC pipe leak at a joint, you can use a PVC pipe repair coupling or a PVC pipe repair epoxy. First, turn off the water supply to the pipe. Then, clean and dry the area around the leak. Apply the repair coupling or epoxy according to the manufacturer's instructions. Allow it to cure before turning the water supply back on.
The quickest fix for a leaking pipe is to use a pipe repair clamp or a pipe repair tape to temporarily stop the leak until a permanent solution can be implemented.