Scr looks like a regulator IC. So keep the scr in such a way that its name should face us. then from left it will KAG.
A diode mainly consists of only 2 terminals(anode,cathode).A SCR mainly contains one more terminal called GATE.The main purpose of the gate in an SCR is just to provide pulses.The main draw back of SCR is it is not fully controllable device.
After a medium power SCR (Silicon Controlled Rectifier) has fired, the voltage across the anode-cathode terminals typically drops to a low level, usually around 1 to 2 volts, depending on the specific SCR and the load conditions. This low voltage indicates that the SCR is in a conducting state. The exact voltage can vary based on factors such as the current flowing through the device and its thermal conditions.
silicon controlled rectifier is a 3 terminal 4 layer device which has 2 consecutive P N junctions here the three terminals called anode, cathode and gate gate controls the conduction of the scr but diode just conducts in forward bias and blocks in reverse bias
The SCR's gate electrode is used to turn the SCR on, i.e. fire it.
The positive terminals in voltmeters and ammeters are generally indicated by a red coloring and a + (plus) symbol. Negative is generally black and - (minus).
A diode mainly consists of only 2 terminals(anode,cathode).A SCR mainly contains one more terminal called GATE.The main purpose of the gate in an SCR is just to provide pulses.The main draw back of SCR is it is not fully controllable device.
Anode, Cathode and Gate. Like in a SCR
After a medium power SCR (Silicon Controlled Rectifier) has fired, the voltage across the anode-cathode terminals typically drops to a low level, usually around 1 to 2 volts, depending on the specific SCR and the load conditions. This low voltage indicates that the SCR is in a conducting state. The exact voltage can vary based on factors such as the current flowing through the device and its thermal conditions.
== ==
To identify and connect the terminals of a 3-way switch in a circuit, you need to locate the common terminal, which is usually darker in color or labeled as "COM." The other two terminals are the traveler terminals. Connect the common terminal to the power source or light fixture, and then connect the traveler terminals to the other 3-way switch in the circuit. This setup allows you to control the light or device from two different locations.
To identify and connect the terminals of a three-way switch in a circuit, you need to locate the common terminal, which is usually darker in color or labeled as "COM." The other two terminals are called "traveler" terminals. Connect the incoming power supply to the common terminal and the outgoing power to the other two traveler terminals. Make sure to follow the wiring diagram for the specific switch to ensure proper connection.
because it is gcr not scr
silicon controlled rectifier is a 3 terminal 4 layer device which has 2 consecutive P N junctions here the three terminals called anode, cathode and gate gate controls the conduction of the scr but diode just conducts in forward bias and blocks in reverse bias
The SCR's gate electrode is used to turn the SCR on, i.e. fire it.
The positive terminals in voltmeters and ammeters are generally indicated by a red coloring and a + (plus) symbol. Negative is generally black and - (minus).
You can see it on the connection on the inside of the package.
thyristor can be scr or triac scr is strictly dc a triac is back to back scr's with a common gate two scr's back to back can be gated independently scrs cost less than triacs an scr can be combined with a full wave bridge to make an equivalent to a triac but this gives an additional 1.5V forward voltage drop