R = E / I = 12 / (240 x 10-6) = 50,000 ohms = 50 KΩ
The first thing you need to know is the internal resistance of the current source, the voltage source will have the same internal resistance. Then compute the open circuit voltage of the current source, this will be the voltage of the voltage source. You are now done.
Ohm's Law Voltage = Current x Resistance V = I x R I = 9/5000
Voltage source: is any source that voltage and amperage come from. Resistor: is any part of a circuit that consumes that energy!
For an ideal current source, this means replace the current source with an open circuit. Resistance can then be calculated across the terminals.
A source of voltage, such as a battery or generator, creates an electric potential difference between its terminals. This potential difference drives electric charges, typically electrons, to move through a conductor, generating an electric current. The flow of these charges occurs when a closed circuit is established, allowing the charges to return to the source, completing the circuit. The rate of this flow is determined by the voltage and the resistance of the circuit components.
By using Thevenin's theorem we can make a complex circuit into a simple circuit with a voltage source(Vth) in series with a resistance(Rth)
A source vibrating with simple harmonic motion produces a sinusoidal wave.
The first thing you need to know is the internal resistance of the current source, the voltage source will have the same internal resistance. Then compute the open circuit voltage of the current source, this will be the voltage of the voltage source. You are now done.
A good energy source for a simple circuit is a battery. Batteries provide a consistent and portable source of electrical energy that can power various electronic devices and components in a circuit.
Voltage will be constant. Resistance is dependent on the components in the circuit. Source: Electronics Technician for the US Govt
a power source, path, and load or resistance.
Before constructing a simple circuit we must first have in mind which type of source is to be supplied to the circuit . A simple circuit may consist of the following components such as capacitors, resistors , inductors etc
A: As current approaches infinity on a device it is known as a current source.
You require a power source, a conductor and a load.
Ohm's Law Voltage = Current x Resistance V = I x R I = 9/5000
Voltage source: is any source that voltage and amperage come from. Resistor: is any part of a circuit that consumes that energy!
To test for a short circuit in a circuit, you can use a multimeter set to measure resistance. Disconnect the power source, then place the multimeter probes at different points in the circuit. If the resistance reading is very low or zero, it indicates a short circuit.