0
This blue filter sounds like a filter/dryer and cannot be removed for cleaning by the homeowner. The larger copper tube is the low pressure side of the system, unless it is a heat pump. >>>>> As noted above the larger tube is the suction line. The filter is a refrigerant filter/dryer. If this is a heat pump the flow is bi directional (either way). The 2 access ports are for checking the pressure drop through it. The pressure drop will indicate if/when it is clogged and needs to be replaced. It is not servicable.
What else can I help you with?
Why Don't we use odd number of tube passes in Shell and Tube Heat Exchanger?
It is difficult from cleaning point of view. Both end chambers have to be removed so as to clean the heat exchanger with odd nos of passes. Thanks & Regards Priyanka Karkera
How do you clean drinages using conveyor belts?
Cleaning drainages using conveyor belts involves a system where debris and sediment are continuously removed from the drainage system. A conveyor belt is placed within the drainage channel, where it collects waste material as it moves. The collected debris is then transported to a designated disposal area, ensuring efficient and effective cleaning. This method minimizes manual labor and enhances the speed of drainage maintenance.
How do make a suction device?
To make a suction device, you will need a container with a sealed top, a tube, and a way to create a pressure difference. One common method is to create a vacuum by sucking air out of the container using a pump or your mouth. As the air is removed, the pressure inside the container decreases, causing the outside air pressure to push the liquid up the tube and into the container. This creates suction, allowing you to pick up liquids or small objects.
What is the difference between temporary and permanent fixings?
one can be removed which is temporary and one can not be removed permannent
What is the feature of fixed-fixed bridge?
A fixed bridge is a Dental Prosthetic which uses two good teeth, one on each sides of the space, to support the prosthetic. This type of bridge is permenant and can not made to be removed, thus the word fixed bridge. The bridge can span over large spaces replacing various teeth. Care must be taken in cleaning a small space above the area of missing teeth on the bridge. A partial bridge is another way to replace missing teeth, but this is the kind that can be removed John Dental Consultant EagleDentalClinic.com
What components are typically removed when upgrading a bicycle's drivetrain system?
When upgrading a bicycle's drivetrain system, components that are typically removed include the chain, cassette, front and rear derailleurs, and possibly the crankset.
Where can one take an old bicycle to have rust removed?
A bicycle shop that restores bicycles is a place where you can take a bike to have rust removed. Additionally, one could use lime juice and steel wool to remove rust from their bike.
Which component should be removed before cleaning a laptop?
battery
What is the best way to remove a stubborn bicycle chain using a bicycle chain tool?
To remove a stubborn bicycle chain using a bicycle chain tool, first, position the tool on one of the chain links. Then, turn the handle of the tool to push the pin out of the link. Repeat this process for each link until the chain is fully removed. Make sure to apply steady pressure and use the tool correctly to avoid damaging the chain or the tool.
Can the Weber Performer propane grill be removed from the cart for cleaning?
Yes, the manual provides instructions for proper cleaning.
Why does a balloon collapses when air is removed from it?
A balloon collapses when air is removed from it because the pressure inside the balloon is higher than the pressure outside. As the air is removed, the pressure decreases inside the balloon causing it to shrink.
What is the stock fuel pressure for a 1992 GMC Typhoon?
Stock base fuel pressure is 42 psi. This is the pressure when the vacuum hose is removed from the fuel pressure regulator. The vacuum hose must be plugged when its removed from the regulator.
Deep teeth cleaning hurt?
Deep dental cleaning can hurt. This is usually due to the amount of plaque being removed or tooth sensitivity.
Is it necessary toi removes braces when having a dental cleaning?
No, braces don't have to be removed before a dental cleaning; otherwise, that would be a pain!
Is the ac line under pressure and if so how do you relieve it to replace the compressor?
Yes the ac lines are under pressure. The high side is under dangerously high pressure. The Freon needs to be removed by a reclaiming machine and the pressure will be removed.
Why should loose dust and debris be removed prior to cleaning surface?
Dust and debris should be removed by vacuum cleaning rather than by sweeping or compressed air blowing that tends to redistribute contaminants rather than remove them.
All of the air is removed from a sealed metal can After the air has been removed the can looks as if it were crushed Why?
It means that the air pressure that sealed the can - can not be removed
