answersLogoWhite

0

What else can I help you with?

Continue Learning about Engineering

Where is the jet engine from?

The Germans invented the first operational jet engine during WW2.


What is the hot section of a jet engine the compressor or the turbine?

the hottest point of the jet engine is the combustion chamber


What is the new jet engine?

there is apparently a jet engine designed in new zealand by a josh and camden Thompson that exhilarates its self its turbo jet design bringing the ids infinite drive system compresses the air and fuel then uses the rear fan to push even more air and compress even more ask your q about the infinite turbo jet


Was it a romanian that invented the jet engine?

A Romanian, Henri Coanda, developed an engine in 1910 that was similar to the modern jet engine. Coanda's engine required an external motor in addition to the jet engine so most people accept that his development is not classed as the jet engine that was later developed by Sir Frank Whittle in Britain. Whittle produced the first jet engine that was self supporting and ran without the aid of external equipment.


What advantages has closed loop hydraulic systems over open loop hydraulic systems?

A closed loop system does not permit the escape or waste of the working fluid.open system:A bucket of water with a hole in the bottom that allows a stream of water to fall upon the blades of a turbine and spin it, performing work, can be considered an open system because the water, the working fluid, is not captured and recirculated for re-use but allowed to fall on the ground and drain away.(I have ignored possible return methods such as the earth's weather system, city storm drains, wells and manpower, and the water utility for this example)A better example might be that of a jet aircraft engine. The fuel is burned to create hot pressurized gas, which is the working fluid. The working fluid expands through the engine's turbine, turning it and producing work. The working fluid is not recovered, but thrown away into the air.closed system:The hydraulic system that lifts the bed of a dump truck and the power steering system in a car are both closed systems because in each one the working fluid is returned to a closed tank for re-use after it has been used to perform work.

Related Questions

Is a jet engine in flight an open or closed system?

its an open system b/c when it gets started it releases heat and also it takes lot of fuel (NED prof.)


How does a jet ski engine cool?

A jet ski engine typically cools through a closed-loop cooling system that uses water from the lake or ocean. As the engine runs, water is drawn into the cooling system, where it circulates around the engine to absorb heat. The heated water is then expelled back into the water body, while a heat exchanger or a thermostat helps regulate the engine temperature. This system ensures efficient performance and prevents overheating during operation.


How does a jetski engine cool?

a jet ski uses the water its in to cool the engine through various hoses wich pass through its engine. if its a closed loop system, it uses a radiator in much the same way as a car. the same water/antifreez is constantly cooled by the radiator.


What is louder a jet engine or a drill?

jet engine


What does a main jet do?

The main jet provides the air/fuel mixture for an engine running with the throttle open. At idle, the function is handed over to a smaller jet, for tick over. Under acceleration, other jets may open to give more power.


How are the propulsion systems of a biplane different from those of a fighter jet?

The propulsion system of a biplane would be a piston engine driving a propellor, while a fighter jet is jet propelled.


How can a jet engine be integrated into a car for enhanced performance and speed?

Integrating a jet engine into a car for enhanced performance and speed involves modifying the car's design to accommodate the engine's power and airflow requirements. This can include redesigning the chassis, fuel system, and cooling system to handle the increased power output and heat generated by the jet engine. Additionally, the car's drivetrain and suspension may need to be upgraded to handle the increased speed and acceleration provided by the jet engine. Overall, integrating a jet engine into a car requires careful engineering and customization to ensure optimal performance and safety.


Who was the inventor of the jet engine?

Frank Whittle was the invetor of the jet engine.


Where to buy a mini jet engine?

You can but a mini jet engine on ebay.


Where is the jet engine from?

The Germans invented the first operational jet engine during WW2.


What was the first jet engine made of?

jet metel


What is use for jet fuel?

The combustion of the jet fuel in the engine of a jet aircraft propells the craft forward when it exits the nozzles of the jet engine(s) at high speed.