answersLogoWhite

0

my thinking is it just cranksbut no start, when you put power to this wire the should be clicking sound near trottle body if click is heard the leave power on it it should start but if not hot when key is off will cut off with key from battery you have to disconnect the hot wire to shut engin off

for test you can do from battery ,but must be keyed hot if that is problem

User Avatar

Wiki User

13y ago

What else can I help you with?

Continue Learning about Engineering

What band is low voltage?

Less than or equal to 1KV comes under Low voltage.


Which voltages are supported by a Toshiba power supply?

The input voltage range for the Toshiba power supply is AC 100V - 240V. The output voltage is DC 19V / output current is 4.74A. This power supply comes with a power cord and packaging will state voltage recommended for the product.


Why in a circuit using power I equals Watts divided by Volts when you increase voltage the current will reduce so why does this differ from Ohms law when you increase voltage the current increases?

When you increase voltage (V) then, to get the same total power (W), the current (I) must be decreased. This result comes from the Power Law: Power = voltage x current Ohms Law does not deal with power at all, it deals only with the relationship between voltage, resistance and current: Voltage = resistance x current


How as the blank applied to a circuit increases the power and the current also increase?

answer is actually voltage


Why series resonance is called voltage resonance?

Series resonance is called voltage resonance because at resonance frequency in a series RLC circuit, the impedance of the inductor and capacitor cancel each other out, resulting in minimum impedance. This causes the total voltage across the circuit to be maximized, leading to a peak in voltage across the components at resonance. This phenomenon is known as voltage resonance because it results in a maximum voltage across the circuit at that specific frequency.