Yes, an example is an automobile's ignition coil, which is energised from the battery, via the contacts within the distributor. The contacts open and close, supplying the ignition coil with pulsating current.
If the input is pulsating DC, then the output will be pulsating DC. It will not be shaped the same, but it will be close, depending on the frequency and rise and fall time in comparison with the inductive reactance of the transformer.
A "Rectifier" converts AC current to pulsating DC current.
The frequency of pulsating DC, often referred to as pulsating direct current, is determined by the rate at which the voltage alternates between its maximum and minimum values. In a typical scenario, this frequency corresponds to the frequency of the alternating current (AC) supply from which it is derived, such as 50 Hz or 60 Hz. Pulsating DC can be generated through rectification of AC, leading to a waveform that oscillates but does not alternate in polarity. The frequency of the pulsating DC is thus defined by the rectification process and any filtering applied to the output.
Transformers are not intended to be operated in DC. DC does not provide the continuously fluctuating current that a transformer requires in order to function. On DC, a transformer will act as a transient mode inductor, and settle out to a high current state, destroying itself.
Transformer or instrument transformer. It can increase and decrease current output.
Diodes are used after a center-tapped transformer in a DC to AC inverter to rectify the alternating current (AC) output of the transformer into pulsating direct current (DC). This rectified voltage is then smoothed using filters to produce a more stable DC waveform. The diodes act as one-way valves, allowing current to flow in only one direction, thus converting the AC voltage into a pulsating DC voltage.
If the input is pulsating DC, then the output will be pulsating DC. It will not be shaped the same, but it will be close, depending on the frequency and rise and fall time in comparison with the inductive reactance of the transformer.
A "Rectifier" converts AC current to pulsating DC current.
The transformer cannot be used in the DC supply because it keeps on alternating its current, whereas the DC supply current should be constant.
No. A constant DC current of sufficient magnitude induces smoke in a transformer.
A transformer does not use a filter. You may be asking about the use of a filter in a power supply. A power supply uses a filter to change pulsating DC from the rectifier into smooth DC for the circuits that the power supply powers.
The frequency of pulsating DC, often referred to as pulsating direct current, is determined by the rate at which the voltage alternates between its maximum and minimum values. In a typical scenario, this frequency corresponds to the frequency of the alternating current (AC) supply from which it is derived, such as 50 Hz or 60 Hz. Pulsating DC can be generated through rectification of AC, leading to a waveform that oscillates but does not alternate in polarity. The frequency of the pulsating DC is thus defined by the rectification process and any filtering applied to the output.
Transformers are not intended to be operated in DC. DC does not provide the continuously fluctuating current that a transformer requires in order to function. On DC, a transformer will act as a transient mode inductor, and settle out to a high current state, destroying itself.
Because of how a transformer works. Basically a transformer have a primary and a secondary winding sitting close to each other, with the primary connected to the ac source. Pushing ac through the primary wionding creates a pulsating magnetic field. Pushing a pulsating magnetic field through the secondary winding creates an electric current in it. That current will also be ac, but dependent on the number of turns in the windings it will have another voltage. DC don't give a pulsating magnetic field from the primary winding, and a stationary magnetic field won't generate any electricity in the secondary winding.
Transformer or instrument transformer. It can increase and decrease current output.
No, the current has to change for a voltage to be induced in the transformer.
The transformer used in mobile is pulse transformer which operates at very high frequency pulsating DC in order to make charger energy efficient and light weight.