answersLogoWhite

0

No. The last 10 (The Barry Ten) were removed into the care of Vale of Glamorgan Council. Two have subsequently been restored and the last 8 are stored in "scrapyard condition" at the Barry Island Railway.

User Avatar

Wiki User

∙ 17y ago
User Avatar

What else can I help you with?

Continue Learning about Engineering

Why PRDS used in thermal power plant?

they work parallel to power generating turbines. The only difference between prds and turbine is that prds give only process steam by simply reducing the pressure of incoming steam while a turbine generates power out of that pressure reduction, and also give left out steam as process steam.


Is a steam heating system more economical than natural gas?

Steam heating is a legacy system left over from previous generations. It's less efficient thant modern heating systems. However it's often not economical to rip out a steam heating system and then replace it.


Dry saturated steam is in a semigaseous state?

No. If you refer to the Temperature/ specific entropy (T - s) diagram for steam, the line segment to the right of the critical point (the point of zero gradient) of the curve is called the dry saturated line and the left segment is the satuated vapour line. As self-explanatory as it sounds, dry saturated steam is on the dry saturated line depending on the given temperature or pressure. The quality (dryness fraction) on the dry saturated line is by definition 1, that means there is no portion of it as vapour. Hence it is in a fully gaseous state.


What is the difference between steam turbine and water turbine?

turbine is driven, engine drives. in reality nothing, both use steam pressure to create a desired output. motion, turbine has 1 moving part that spins on it's axis. engine has many moving parts spinning an axis (crankshaft) I really feel there is a huge difference in the way the two power generating sources work. The turbine uses steam at higher pressures and in my view less efficently than a closed piston power source does. lower pressures can be used in the closed piston type engine and levels of output can be changed by simply adding more cylinders or expanding the diameter of the piston,there are more moving parts than a turbine but if you figure in the steam adjust valves probally not that many more. I have never understood why an turbine is used as opposed to closed piston type engine. Thank you. _____________________________________________________________________ A turbine opperates in a way similar to either a jet engine, or an old water-wheel. In either case, a steam turbine converst the thermal energy of the steam to rotary mechanical energy much more efficiently. An engine (either a single set like a locomotive, or a block like a gas or diesel engine) uses both the pressure and the expansive poer of the steam to move a piston. The piston is connected to a rod which connects the backand forth motion of the piston to the rotary motion of the crankshaft. A turbine is most fuel efficient in situations where full power is used most often, such as a powerplant, where the tubine spins a generator. An engine is most efficient in low-speed, high torque applications, such as a pisotn set coupled to the drive wheels of an old steam locomotive. The steam produced for a steam engine drives a piston up and down or left to right, while the steam produced for a steam turbine turns the turbine itself.


What is Robert Fulton's achievement?

Fulton's steamboat was built on the East River at the ship yards of Charles Brownne. After disappointments and delays, Fulton left New York on his steamboat for Albany on August 17, 1807. He made the trip in thirty-two hours and successfully demonstrated to the world the possibilities of steam navigation.

Related Questions

What is the name of the person who shovels coal on a train?

The firemen. In addition to that he maintains water level in the boiler along with the engineer, watches steam pressure and watches safety on his side of the cab which is the left (facing forward) except the opposite side on Chinese made steam locomotives.)


Binweevils where is the crown today?

On July the 8th the crown is in kipps scrapyard on the left behind the far left RED pin this is correct


What handed is barry bonds?

Barry Bonds is left handed


When did Barry Rand leave Xerox?

Barry Rand left Xerox in 1999.


What is Gareth Barry's prefered foot?

left


How do you change the left rear marker bulb in a 2000 Volvo s40?

cant change bulb will need to change the the light as well get one from scrapyard will cost about £5


What are baseball player Barry Moore's physical stats?

Barry Moore is 6 feet 1 inches tall. He weighs 190 pounds. He bats left and throws left.


What are baseball player Barry Zito's physical stats?

Barry Zito is 6 feet 2 inches tall. He weighs 205 pounds. He bats left and throws left.


What are baseball player Barry Bonds's physical stats?

Barry Bonds is 6 feet 1 inches tall. He weighs 185 pounds. He bats left and throws left.


Can you play left 4 dead 2 on steam if you buy from gamestop?

Yes, you can play left 4 dead 2 on steam if you buy from Gamestop.


Where can you download left for dead PC?

Try downloading steam and then download it off the steam website.


Is there any Steve and Barry store locations left?

They are out of business closed all stores in Jan 2009