Either the gaskets you put on aren't in place correctly (you need washers on both sides), or you didn't tighten the bolts enough. If you didn't replace them, that's likely your problem. Always use new washers when replacing hardware. If you did use new ones, there's also always the possibility that there's some minor debris or mineral residue in the holes if you didn't clean them good enough.
You also need to make sure that the tank is set correctly on the bowl - any misalignment can also cause a leak.
First tighten the bolts up, but don't go too far as you can crack the porcelain. If that doesn't work, drain it and start over. Take the bolts out, clean everything including the holes where the bolts go through, make sure you've got new rubber washers and that they're correctly placed against the tank surface under the metal washers. Make sure the bolts are aligned straight and that they're in the middle of the hole when you tighten the nuts.
To stop a weep hole from leaking, first ensure that the hole is not clogged with debris, which can cause water to back up. If the hole is clear but still leaking, you can apply a waterproof sealant around the exterior of the weep hole to minimize water flow. Additionally, consider adjusting the drainage system or grading around the area to redirect water away from the weep hole. If problems persist, consulting a professional may be necessary to address underlying issues.
If you are having issues with leaking under your sink, it could be as simple as a loose pipe fitting. Try first to tighten all of the screws. If you still experience leaking, you should contact a local plumber.
Anchor bolts are used to secure items to concrete. They can be wet-set meaning inserted into the concrete while it is still hardening or the concrete can be drilled and the anchors set in to them.
With the water turned off on all the water devices in your house, see if your water meter is still running.
George eastmans invention changed society because he made the camera and still in in use today.
Where is it leaking from? Could be front or rear seal or coolant lines Did you change gasket when you changed fluid?
Coolant lines? Shift linkage? could also be the rear or front seals leaking
it could be leaking from some were above and its driping on the pan causing it to look like its leaking from the pan or if you over tourk the bolts it will warp the pan causing it to leak
Either the water pump impeller is loose on it's shaft, or you have a leaking head gasket.
it could possibly have either a blown head gasket or intake manifold gaskets leaking
If it is leaking coolant. And you changed the thermostat. I would then move to this section. Flush the radiator and the heater core. This can be done at a certified shop with a reliable mechanic.
The better question is what is leaking transmission fluid?
Pressure test the cooling system to track the source of the leak.
Not to my knowledge...but there is a gasket around the timing cover that will leak antifreez if it goes bad. It is a pain to replace, but it can be done. If you've replaced the water pump and it's still leaking (as was my case), then go one step further and replace the gasket around the timing cover. ***caution*** use a repair manual before attempting this!!! There are ***a lot *** of bolts to undo and some require sealant on them when they are replaced. The manual will tell you which ones to put sealant on. steve phx az
No
I would recommend getting a transmission filter kit, and drop the pan entirely and just change the gasket, along with the filter. There's a specific pattern to tighten the pan bolts. (usually some kind of criss-cross pattern) Use a torque wrench and figure out EXACTLY how tight they should be and see if it still leaks. If it does, the pan itself might be distorted.
try the cool line fitting from the radiator to the transmission i just had that problem on a 1994 mercury Sometimes you can leak out of the tailhousing of your transmission if the housing seal is slightly damaged