it is that length in which steel completely solidify in continuous casting process
A: As cable lenght increases the impedance changes with frequency especially at half wave lenght where at some frequency the impedance can be zero. The impedance is a function of capacitance inductance and resistance in the cable
Divide the lenght of the roll by 2*(pi^2) and round to the next number.
Crank lengths are used because the moments at the edge strips are negative while that at mid span are positive so reinforcement are alternatively provided at the top and bottom respectively.. so just to have connection between the reinforcement and for the slab to behave as a single unit by providing continuous bars, cranking is done in slabs..
What size nozzles? What is the GPM rating What is the available pressure What lenght of the hose (fricton losses)
Scalene sides are different lengthed isosceles two of the 3 sides are the same equilateral, the three sides are the same lenght and are all at 90degrees
0.2911cm
yes
That depends on the direction in wich you apply the load. If the Load is applied in the direction of the lenght of the continuous fibre this is definitely the case. However if the load is applied perpendicular on the fibre direction of the continuous fibre the CSM will be the one with the higher strenght of the two.
lenght is 8850 meter
A triangle with all sides the same lenght is an equilateral triangle.
Lenght
generally a 4:1 ratio is suggested (25%)
all u need to do is is add lenght by lenght and wighth by wighth
all you have to find out how much there is in a lenght so the unit would be the amount 12 or 43 any on the calculation
lenght times width times height There is no formula. Length is a linear measurement using appropriate units.
2km
lenght