tune up. new plugs wires and distribitor cap. and maybe new fuel filter and air filter
smh = "shaking my head"
The main reason is the motor’s variable speed behaviour. When the voltage applied to the armature of a DC motor increases, themotor’s speed increases correspondingly.Another reason is the DC motor can develop full torque from zero up to its base speed. This constant-torque characteristic allows DCmotors to be used on applications such as conveyor belts, elevators, cranes,extrudesand mixers,amongstothers. The full torquefrom zero speed is useful when the application needs to be stopped when fully loaded, and then got moving again
No. Once a thread is stopped you cannot restart it.
It depends on a lot of factors - if the stepper is stopped between steps, the efficiency is zero. Earlier this week, I had a small nema23 size motor driving a pump and got about 20w of mechanical power out for about 40w DC in, or about 50% under optimal conditions.
Sizing circuit breakers for motors falls into a different category. Because of the inrush of current when the motor is in the stopped position, the breaker has to be sized to allow for this. Breakers usually are 250% of the nameplate full load amp rating. The wires that feed the motor are sized to 125% of the full load amps of the motor.
Bad motor mounts and needs a tune up probably
possible warped brake pads or warped rotor Shaking while stopped, can be caused by broken motor mount, or engine miss.
It's engine is probably on.
Have your motor mount checked.
If the motor is shaking in your Kia Sephia, you probably have loose motor mounts. Simply tightening these up will stop the engine from shaking and vibrating.
You can but there needs to be some changes:collided with not intointo is spelt like this - intonot stopped but had stoppedit is a little bit confusing saying the driver had stopped probably better to say the car had stopped in that case use which not whoseThe driver of the Suzuki motor car collided with the rear of the BMW motor car, pushing it into the rear of the Toyota motor car which had stopped.
A vehicle's engine is sometimes call a motor. The electric fan's motor stopped working. I want to get a motor bike.
bat motor mounts cause the shaking a knock sensor realizing its shaking is the light get new mounts
Motor or transmission mounts. That or your transmission is slipping one way or the other.
It is scared of something, is there an Escalade around? Seriously, shaking while driving could be wheel balancing or front end alignment. Shaking while at idle or what seems to be coming from the engine might be a motor mount.
The motor may have quit working .
most likely. 65;