no you should never wear them
Drilling rig tongs are mechanical devices used to grip and turn the drill pipe during drilling operations. They consist of two halves that close around the pipe and are powered by hydraulic or manual mechanisms to apply sufficient torque for making or breaking connections. The snubline, typically a strong cable or rope, serves to control the movement of the tongs and the drill pipe, preventing it from rotating uncontrollably and ensuring safety during operations. This helps maintain stability and precision when handling heavy drilling equipment.
To see this simply go to any old factory that was around before electric motors. You will see the reminants of an intricate power delivery system to drive rotating equipment. Long axles ran across the roof of the building, with power take off pullies every few feet. Each machine was powered from one of these pullies, so each machine had a belt running to it from the cieling. To stop and start an individual machine a clutch was needed, as stopping the steam engine or whatever else powered the whole plant was not an option. All the rotating equipment posed a huge safety hazard, and I'm willing to bet arms were lost to those belts. If a belt came off the pulley the axle had to be stopped to (safely) get that machine on-line again. Electricity de-centralized this power system. Instead of one big engine powering everything, small motors powered individual tools. The need for all the belts and axles was eliminated. Machines could be run and repaired independently. Machines could be stopped and started with a cheap switch, not an expensive clutch. Also, electric lighting was safer and brighter than gas. IIRC fires were serious problems in plants that produced lint or dust because of the explosion hazard.
I think you are confusing your terms. The term 'stator' (not 'stater') is used to describe the stationary part of a rotating machine (motor, generator), as opposed to the term 'rotor' which describes the rotating part. No part of an autotransformer is normally described as a 'stator'. An autotransformer has a laminated silicon-steel 'core', around which are placed 'windings'.
Usually disconnects are placed around any equipment that you may have to do maintenance on in the future and don't want to have to take larger outages than necessary. If the current transformer is on a substation bus, and you don't want to take an outage to that bus, but would like to take a look at the CT's, you should put disconnects around it to allow such maintenance activities.
All in good time, powered flight has only been around for just over 100 years. Right now the cost and technology isn't in place.
No
true
That is a white light.
no, it's the Earth that is constantly rotating around the Sun
by the earth rotating around the sun while the moon is rotating around the earth.
All around white light
A white light.
because earth is rotating around itself while revolving around the sun
Earth revolves around the sun while rotating on its sides
No. If you have three suns rotating around each other, that would mean that an object would have to be rotating around two other objects that are rotating around the other two objects, which is rotating around the two original objects. It just can't work
All around white light
All around white light