0
What else can I help you with?
What do you need to use as a beam to span twenty feet on a deck?
Use a steel beam.. That would be code.. steel w10x15 (50ksi) I beam.
Name of a steel beam used to support a ceiling or floor?
I-beam
What size steel eye beam can safely span 14 feet with a point load of 4000 pounds in the middle?
There are a lot of considerations to be taken into account for sizing steel shapes, especially for a residential home. For instance, what are the load imposed upon the beam? How will the beam be supported? What environment will the beam sit in (i.e. high humidity, moisture, vibration)? A licensed professional engineer or architect in your state can better answer this question.
What is a minimum length for beam suppot on bearing wall?
That depends on what the beam is supporting above. Ideally 150mm bearing is the minimum. I have seen as little as 50mm! But any engineer would frown upon this.
Who is the inventor of the steel you beam?
ben Franklin
How do you remove a load bearing wall?
Support the load whatever it is, roof, second floor, generally by putting a temporary beam under the joist inside of the existing wall, tear the wall out and put in a beam to carry the load. How big the beam needs to be depends on what the load is and how long the span is. Support the beam on each end and remove the temporary beam. These are the general steps, each project is going to be slightly different and has to be figured on it's own.
What is the recommended size and material for the support beam needed to reinforce a load-bearing wall in a residential structure?
The recommended size and material for a support beam to reinforce a load-bearing wall in a residential structure is typically a steel or engineered wood beam that is sized according to the specific load requirements of the wall. It is important to consult with a structural engineer to determine the exact specifications needed for the support beam.
How much weight the steel you beam hold?
The weight a steel I beam can hold depends on its dimensions, material properties, and the way it is supported. Steel beams are typically rated based on their load-bearing capacity in pounds per foot or kilonewtons per meter. To determine the exact weight a specific steel I beam can hold, you would need to consult structural engineering tables or software that consider factors such as the beam's span, section modulus, and moment of inertia.
Torque specs on main bearing beam for sr20det?
beam for sr20det?
How do you replace the low beam headlamp on a 2003 Nissan Altima?
You must remove the front bumper!
What do you need to use as a beam to span twenty feet on a deck?
Use a steel beam.. That would be code.. steel w10x15 (50ksi) I beam.
How do you replace the low beam headlight located on a 1999 Toyota Sienna?
Open the hood, remove the rubber boot, unplug the wire connector, unclasp, remove the burned bulb and replace with the new one.
Name of a steel beam used to support a ceiling or floor?
I-beam
How do you replace drivers side low beam headlight on Mazda cx7?
you have to remove the whole mud flap above the tire.
What size steel eye beam can safely span 14 feet with a point load of 4000 pounds in the middle?
There are a lot of considerations to be taken into account for sizing steel shapes, especially for a residential home. For instance, what are the load imposed upon the beam? How will the beam be supported? What environment will the beam sit in (i.e. high humidity, moisture, vibration)? A licensed professional engineer or architect in your state can better answer this question.
What actors and actresses appeared in On the Great Steel Beam - 1914?
The cast of On the Great Steel Beam - 1914 includes: Harry Gripp as Lombardi
What is the recommended type of steel beam for deck construction?
The recommended type of steel beam for deck construction is typically a wide-flange beam, also known as an I-beam. These beams provide strong support and stability for the deck structure.
