answersLogoWhite

0

To become an architect, one typically needs a professional degree in architecture, which can be a Bachelor of Architecture (B.Arch) or a Master of Architecture (M.Arch). These programs often require rigorous coursework in design, building technology, and environmental systems. Additionally, aspiring architects usually need to complete an internship and pass the Architect Registration Examination (ARE) to become licensed professionals. Some may also pursue further studies in specialized areas, such as urban design or landscape architecture.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Continue Learning about Engineering

West coast university panama degree valied?

Hi I did some investigation on the west coast univ. I found that some of the accredited Universities is affiliated with them. that the degrees they office is legal degrees


What are some good bachelor degrees?

Here is a website that will show you the highest earning bachelor degrees out there. http://www.cnbc.com/id/29408064/Highest_Paid_Bachelor_s_Degrees_2010


How much energy is needed for a heat pump defrost cycle?

About 10% during the outdoor temperature from about 40 degrees to 20 degrees. Not a lot beyond those temperatures that make frost on the outdoor coil...assuming you have a unit with a good electronic defrost control.


What are some inventions needed today?

some inventions needed today go something like this..... something that helps u with cooking , cleaning and find u the right job . That's what i would say.


How can we get maximum angle of 90 degrees in RC phase shift oscillators?

To achieve a maximum phase shift of 90 degrees in RC phase shift oscillators, you can use a combination of three RC stages in series, where each stage contributes 60 degrees of phase shift at the desired frequency. By carefully selecting the resistor and capacitor values to ensure that the total phase shift across the three stages reaches 180 degrees, you can then use a phase inverter, such as a transistor or an op-amp, to provide the additional 180 degrees needed for positive feedback. This setup ensures that the oscillator can sustain oscillations at the desired frequency.