Removing the freewheeling diode in a single-phase semi-converter can lead to several adverse effects. Without the diode, the inductive load will not have a path for the current to continue flowing when the SCRs are turned off, potentially causing voltage spikes and damaging the circuit components. Additionally, the efficiency of the converter may decrease, leading to increased ripple in the output voltage and a less stable operation. Overall, the absence of the freewheeling diode compromises the converter's performance and reliability.
single phase fully control converter
Terminology gets misapplied but a 3-phase converter produces a 3 phase supply from a single phase supply. The only proviso is that generator, converter and motor are all suitably rated and compatible.
This is actually called a single phase half converter and it is used to have an adjustable DC output voltage. It is like a bridge rectifier but two of the diodes are replaced with a solid state switch, SCR for example, and there is also a freewheeling diode in parallel with the load. A half converted can have an output voltage that is adjustable from 0.9*E to 0 volts. It does this be adjusting the firing angle of the switches. There is also a full converted and the difference is that it has an output voltage from + 0.9*E to - 0.9*E volts.
A phase converter converts single-phase, alternating current power to three-phase power. There are two general types, static converters and rotary phase converters. A basic form of rotary phase converter is a single-phase electrical motor with its shaft coupled to a three-phase alternator. A static phase converter converts single-phase power to three-phase power by using electronic switching. They typically convert the single-phase, alternating current to direct current and then electronically synthesize three phase power output for use with three-phase equipment.
Very unlikely. Its 3 phase for a reason, it needs a large voltage/current to power it, single phase won't provide that.
single phase fully control converter
Multimode
you can use a rotophase
I haven't found a single law against it - The only problem with removing it is that it wont pass smog, but if you live in any other county besides Bernalillo, you should be good to go!
A single phase supply can operate a three phase motor with a static converter. No a power supply of computer cannot be fed through the static converter.
See related links and sources below.
Terminology gets misapplied but a 3-phase converter produces a 3 phase supply from a single phase supply. The only proviso is that generator, converter and motor are all suitably rated and compatible.
A rotary phase converter is a device that changes single phase electrical power into multiple phase electrical power.
This is actually called a single phase half converter and it is used to have an adjustable DC output voltage. It is like a bridge rectifier but two of the diodes are replaced with a solid state switch, SCR for example, and there is also a freewheeling diode in parallel with the load. A half converted can have an output voltage that is adjustable from 0.9*E to 0 volts. It does this be adjusting the firing angle of the switches. There is also a full converted and the difference is that it has an output voltage from + 0.9*E to - 0.9*E volts.
The converter is used to allow both SingStar microphones to be plugged in to the PS2 via a single USB port on the PS2.
Of what?
Yes, it can. But it requires a special converter - single to multi-mode.