answersLogoWhite

0

1.removable slatted benches

2.removable hangers w\ hook

3.wooden hooks

4.vents

5.funnel or pipe

6.concrete furnace

7.tight searching taflers

8.mihed scream

User Avatar

Wiki User

12y ago

What else can I help you with?

Continue Learning about Engineering

What is ROR in smoke detector?

really old rapter


What happens if your smoke detectors goes off but there's no smoke?

This may because specs of dust can cause activation of the detector as it has the same effect as smoke. Spiders also can crawl into the sensors which does the same thing- same way with deodrant, paintfumes etc. It also may be because the smoke detector is just faulty.


Why do you have to test an ionizing smoke detector?

You have to test it frequently, the reason is that smoke may be visible or may be not and you want to see all particles that emanate from any kind of smoke, specially during night time when you are asleep. Most of dust/ash particles may not be visible and via ionizing detector they will be!!!! Alarm will go off making alert sound and you will be safe. So, sumirizing, you need to test ionizing smoke detector to see if sensor is in ok condition.


How would one make a lock that is triggered by a smoke detector?

Perhaps a two-stage process. Firstly, gain access to the electrical output in the smoke detector, that drives the noise transducer. Use this (amplified?) to drive the mechanism of your electrically-operated lock.


Guide to install fire smoke detector above false ceiling?

I don't believe that if you place a smoke detector inside a closed space like above a false ceiling , it will have the same effect than if it was attached to the ceiling on the occupied space side. See the related link for some general guidelines and always check local codes or with the fire marshall for specifics.

Related Questions

Why is my smoke detector leaking water?

A smoke detector may leak water due to condensation buildup, a faulty seal, or a leak in the ceiling. It is important to address this issue promptly to ensure the detector functions properly in case of a fire.


What does a beeping horn in your smoke detector mean and a red flash?

A beeping horn and red flash on a smoke detector usually indicate a low battery or a malfunction. It's important to replace the battery or the entire unit to ensure the detector functions properly in case of a fire.


Why is the smoke detector beeping?

The smoke detector is beeping because it is detecting smoke or a low battery.


What are the steps involved in hardwired smoke detector installation?

Turn off power to the area where the smoke detector will be installed. Remove the old smoke detector, if applicable. Connect the new smoke detector to the existing wiring. Mount the smoke detector on the ceiling or wall using screws. Restore power and test the smoke detector to ensure it is functioning properly.


Was the smoke detector proposed for a mission?

actually no, the smoke detector was not proposed for a mission


Can you buy smoke detector tape?

Personally, I have no idea what "smoke detector tape" is.


Why is my hard-wired smoke detector going off in the middle of the night?

Your hard-wired smoke detector may be going off in the middle of the night due to a variety of reasons, such as dust accumulation, low battery power, or a malfunction in the detector itself. It is important to regularly clean and maintain your smoke detector to ensure it functions properly and to replace the batteries as needed. If the issue persists, it may be necessary to have a professional inspect and repair the detector.


Is a smoke a detector like a sense organ?

is a smoke detector like a sense organ


Is a smoke detector like a sense organ?

is a smoke detector like a sense organ


Why does the smoke detector beep?

A smoke detector beeps to alert you when it detects smoke or fire, which could be a sign of danger in your home.


Why does a smoke detector chirp?

A smoke detector chirps to indicate that its battery is low and needs to be replaced.


What technology does a photoelectric smoke detector use to detect smoke?

A photoelectric smoke detector uses a light sensor and a light source to detect smoke particles in the air. When smoke enters the detector, it scatters the light, triggering the alarm.