answersLogoWhite

0

This is due to excess fat in your diet which cannot be digested. Stools may also float due to excess lipid, have an oily appearance and be especially foul smelling. Possible biological causes can be lack of bile acids (due to liver damage or hypolipidemic drugs), defects in pancreatic juices (enzymes), and defective mucosal cells. The absence of bile acids will cause the feces to turn gray or pale. Try taking lot of fiber and water. And cut down on cheese.

Orlistat (Xenical) is a diet pill that works by blocking the enzymes that digest fat. As a result fat cannot be absorbed from the gut and some fat is excreted in the feces instead of being metabolically digested, sometimes causing oily anal leakage.

Also try some digestive enzyme supplements.
User Avatar

Wiki User

16y ago

What else can I help you with?

Continue Learning about Engineering

Why is leakage flux modelled in a transformerequivalent circuit as an inductor?

In a transformer equivalent circuit, leakage flux is modeled as an inductor because it represents the magnetic flux that does not link the primary and secondary windings effectively. This leakage affects the impedance and efficiency of the transformer, as it causes voltage drops and reduces the coupling between the coils. By modeling it as an inductor, we can accurately account for the reactance due to the leakage flux, which impacts the transformer's performance under load conditions.


What is magnetic leakage of a single phase transformer?

The magnetic leakage should be very small and designers go to some lengths to reduce it as far as possible because it causes leakage inductance, which is a bad thing. Ideally the magnetic field must be confined to the magnetic core of the transformer.


What is seat leakage test in safety valves?

Seat leakage is defined as leakage that is internal to a valve-between the inlet and outlet sides of the valve-when the valve is in its closed position. It is not limited to leakage across the valve seat, but also encompasses all leakage across the valve trim when the valve is in the closed position. Leakage across internal trim seals, such as piston rings, and across trim-to-body seals, such as gaskets, can be counted as seat leakage. It is important to note that, while leakage through valve stem packing is of growing concern in the industry, governing industry standards address this type of leakage separately and do not consider it to be a form of seat leakage.


How do you test leakage on equipment?

by measuring the insulation resistance then by usig the formula for finding leakage current leakage current =voltage applied /resistance measured by megger.


When using an antenna to measure leakage the antenna must be elevated from leakage source and ground.?

When measuring leakage with an antenna, it is essential to elevate the antenna above both the leakage source and the ground to ensure accurate readings. Elevation minimizes the effects of ground reflections and interference, allowing for a clearer detection of the leakage signal. Additionally, being elevated helps reduce the influence of nearby structures and obstacles that could distort the measurement. This positioning ensures that the antenna captures the true electromagnetic field generated by the leakage source.