answersLogoWhite

0

That same question was in my science test! The answer is a siphon :D

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What typical pressure sensing device may be used in a low pressure control?

A pressure sensing device commonly used in low pressure control systems is a diaphragm pressure switch. This device operates by detecting changes in pressure through a flexible diaphragm that triggers a switch mechanism at set pressure thresholds to activate or deactivate control functions such as turning a system on or off.


How does a mercury pressure device work?

A mercury pressure device, such as a manometer, works based on the principle that the pressure of a fluid is directly proportional to the height of the fluid column. In a mercury manometer, a column of mercury is used to measure the pressure difference between two points. The difference in height of the mercury column indicates the pressure difference between the two points.


Difference between Threshold voltage and knee voltage?

the voltage at which electronic device operates is callled threshold voltageand the voltage at which device show cinduction in forward biased stste


What is the principle on venturimer works?

A Venturi meter works based on the principle of Bernoulli's equation, which states that an increase in fluid velocity results in a decrease in pressure. The Venturi meter is a device that measures the flow rate of a fluid by creating a pressure difference between two points in a pipe, allowing for flow rate calculations based on this pressure difference.


What is the amperage required for a device that operates at 7500 watts?

The amperage required for a device that operates at 7500 watts can be calculated by dividing the wattage by the voltage of the power source. If the device operates at 120 volts, the amperage required would be 62.5 amps.


How do you make a calibration for differential pressure?

To calibrate differential pressure, you will need a calibration instrument such as a pressure gauge or calibrator. Connect the instrument to the differential pressure device, apply a known pressure, and compare the readings from the device to the instrument. Adjust the device's output if necessary to match the known pressure applied for accurate calibration.


What type of power cord is required for a device that operates on 220v?

A device that operates on 220v typically requires a power cord with a voltage rating of 220v and a compatible plug type for the specific country or region where the device will be used.


Device that operates valves in an internal combustion engine?

Camshaft


What is the Device that operates valves in an internal combustion engine?

the camshaft


What type of power cord is required for a device that operates on 120V AC power?

The device that operates on 120V AC power requires a power cord with a standard 3-prong plug.


Difference between hogger and ejector of condensing turbine?

A Hogger is a device to remove the Air from Turbine inside for creating initial vaccume for start up the turbine means create negative pressure inside Turbine or say creates less pressure than atmospheric pressure in Turbine.An Ejector is a device used in Power plant to remove Undissolved gases from Condenser to avoid any harm to system from these gases.If any correction is required pl. correct it.


What is the maximum current rating for the circuit breaker required for a device that operates at 20 amps?

The maximum current rating for the circuit breaker needed for a device that operates at 20 amps is 25 amps.