Allowable stress would normally refer to design using Allowable Strength Design, also known as working strength design. In this the allowable stress is usually a fraction of the yield strength and can be different for uniform tension and bending. Typically mild steel has a yield strength of about fy=250MPa with allowable stresses in Tension, 0.6fy=150MPa Bending, 0.66fy=165MPa
.08KN/mm2
according to ASTM A36 Marine grade mild steel plate has a tensile strength of 58 - 80 thousand psi.
No, A36 is a mild structural steel and tool steel is a high strength alloy steel
Mild steel, typically containing around 0.05% to 0.25% carbon, is known for its ductility, weldability, and ease of machining, making it suitable for general construction and fabrication. C45, on the other hand, is a medium carbon steel with a carbon content of approximately 0.45%, offering higher strength and hardness but lower ductility compared to mild steel. This makes C45 more suitable for applications requiring strength and wear resistance, such as gears and shafts, while mild steel is preferred for structural applications.
it means not strong
The fatigue strength of mild steel refers to the certain conditions whereby the mild steel suffers fatigue failure.
77gpa
Allowable stress would normally refer to design using Allowable Strength Design, also known as working strength design. In this the allowable stress is usually a fraction of the yield strength and can be different for uniform tension and bending. Typically mild steel has a yield strength of about fy=250MPa with allowable stresses in Tension, 0.6fy=150MPa Bending, 0.66fy=165MPa
.08KN/mm2
i think that it is quite difficult to cut mild steel because of its stiffness/strength
according to ASTM A36 Marine grade mild steel plate has a tensile strength of 58 - 80 thousand psi.
it is the resistance of material to impact(sudden) loading...or..it is the impact energy absorbed per unit area.
what is mean by mild separation of pelvicalyceal system in kidney
Mild steel is a fairly general classification and can cover a considerable variation in material properties. Cold drawn grades in particular will have a higher tensile strength than hot rolled. Something like 400 MPa for yield stress and 500 MPa for ultimate tensile strength is quite common.
Because they were very mean and mild!
Mild means not very severe or serious.