0
What else can I help you with?
What is primary reactor?
This item is normally seen in electrical switch gear (or called "Starter "/ "Motor drive") . This device is to reduce the inrush current during motor starting. Another item "Line reactor" .
What is difference IN DRIVE AND MOTOR?
An electric motor is an electromechanical energy conversion devicewhereas an electric drive is that which involves control of speed or position of the motor.
What is used to start the cpmpressor motor?
A switch
How do i switch a 3 phase motor from low to high voltage?
You can't. You must supply the motor with it's required voltage. If it's a dual voltage motor, follow the wiring schematic on the motor nameplate to switch from low to high voltage.
The device which disconnects the start winding in some split-phase motor circuits after a preset speed is obtained is the?
It is called a centrifugal switch. The switch is in series with the start winding. When the RPM of the motor reaches a certain speed the switch drops the start winding of the motor out of the circuit.
What hot-pluggable external hard drive technology uses shielded cable with lengths up to two meters outside the PC?
esata
What does the transfercase motor do for a 1998 Oldsmobile bravada?
Any tansfercase motor is to switch from 2 wheel drive to 4 wheel drive. It is located behide the transfer case and it has 6-7 wire plug. Only automatic push button 4 wheel drive trucks have the transfer case motor.
Switch for 4 wheel drive on 98 Expedition is not working - could it be a fuse - If so which one?
I belive there is an electric motor/solinoid that engages the 4WD. Switch may be fine.
What component does the starter motor drive to turn the engine?
battery,solenoil coil,cable wires,ignition switch
What is primary reactor?
This item is normally seen in electrical switch gear (or called "Starter "/ "Motor drive") . This device is to reduce the inrush current during motor starting. Another item "Line reactor" .
Can a single pole switch replaced starter?
If you are talking about motor control then the answer is yes. There are two things to take into account though. One, is the motor thermally protected. This is for overload protection. On fractional HP motors it will indicate this on the nameplate. If the motor is not protected, then a fractional HP motor switch should be used. Incorporated into this switch is a heater element that the motor current flows through. If the motor current gets over the motor nameplate rating then the heater trips the switch and shuts the motor off. The other thing is that the switch has to be motor rated, currents and voltage matching the motor nameplate ratings. The specific switch has been designed to open motor currents under full motor loads. An ordinary house light switch is not motor load rated and should not be used for this purpose.
Cavalier 2002 drivers power window seem to work on and off?
You are going to have 2 things to repair with this problem. The window switch and the window motor. The weak motor has melted the inside of the switch. Yep...been there,done that.Replacing the motor wont fix the switch and if you replace the switch the weak motor will melt the new switch.
Is there a way to tell if the power window switch is bad or if it the motor for the switch?
remove switch from where it is mounted using a wire , bridge the connections.if switch is bad, it will work the motor while bridged
What types of hardware are not hot pluggable?
eSATA, Expresscard/54 and USB
Why will your blazer not engage front axles in four wheel drive?
It could be the shift motor on the T Case. Or it could be the automatic shift button switch on the dash.
What does Pam stand for in Linux?
Linux Pluggable Authentication Modules (PAM) provide dynamic authorization for applications and services in a Linux system. Linux PAM is evolved from the Unix Pluggable Authentication Modules architecture.
Is the park switch on a 1976 Chevy pickup wiper motor in the pump or the motor?
It is in the motor.
