0
What else can I help you with?
Where will a router operating system image be copied after the copy flash tftp command is issued?
to TFTP
Which command is used to upgrade an IOS on a Cisco router?
config tftp run
What is the purpose of using the copy tftp flash command on a router?
What is the purpose of using the copy tftp flash command on a router? to back up the current IOS image to a server to restore the IOS image from a server to back up the router configuration to a server to restore the router configuration from flash
What is the command to copy a cisco ios to a TFTP server?
You can use the copy flash TFTP command to copy the IOS to the TFTP server as shown next:Router#copy flash tftpSource filename []?c2800nm-advsecurityk9-mz.124-12.binAddress or name of remote host []?1.1.1.2Destination filename [c2800nm-advsecurityk9-mz.124-12.bin]?[enter]!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!21710744 bytes copied in 60.724 secs (357532 bytes/sec)Router#Just copy the IOS filename from either the show flash or show version command and then paste it when prompted for the source filename.
What is the command to copy nvram to tftp?
To copy the contents of NVRAM to a TFTP server on a Cisco device, you can use the command: copy nvram tftp After executing this command, you will be prompted to enter the TFTP server's IP address and the filename for the backup. Make sure that the TFTP server is reachable and properly configured to accept the transfer.
What command and prompt are used to save a router configuration file to the TFTP server?
RouterC#copy running-config tftp [copy run tftp]
What is the effect of command copy running config tftp?
This command will copy the running configuration (located in RAM) of a Cisco device to a TFTP server. After executing the command you will be prompted for further information about the TFTP server (Server Address, file name, etc.).
What is accomplished by the command copy tftp running-config?
This command will allow you to copy a configuration from a TFTP server to the running configuration of a Cisco device. When you issue the command you will be prompted for further details about the TFTP server. The new configuration will replace the active one (or running configuration) and make any necessary changes.
How do you install ios on 2600 router?
To install IOS on a Cisco 2600 router, first, download the appropriate IOS image from Cisco's website (ensure you have the necessary permissions). Next, connect to the router via console cable and use a terminal emulator to access the command line. Transfer the IOS image to the router using TFTP or a similar method, then use the copy tftp flash command to copy the image to the router's flash memory. Finally, configure the router to boot from the new IOS image by updating the boot system command in the configuration and rebooting the router.
When a router boots what is the default order to locate the Cisco IOS if there is no boot system command?
flash, NVRAM, TFTP server
From what location can a router load the Cisco IOS during the boot process?
TFTP server, Flash
What command and prompt used to load a save configuration file from the TFTP server?
RouterC#cpoy tftp running-config [ cpoy tftp run ]
