A: One example is the gain of an op amp the gain is strictly related to resistors in a closed loop. The gain will change % wise as the resistor change % wise
It will not be possible to measure current unless the circuit is powered and operating.
The current measured at any point in a simple circuit will be the same because current is the measure of electron flow through a circuit. The current flowing through any branch of any circuit (or an entire simple circuit) will always be the same at any point.
The flow in a circuit is called the electric current and it is measured by voltages. The number of volts that are present in the charge will determine the strength of the electric current.
Assuming you are talking about an AC circuit, then the total opposition to the flow of current in an R-C circuit is called its impedance (symbol: Z), measured in ohms. This is the vector sum of the circuit's resistance (R) and its capacitive reactance (XC) -each also measured in ohms.
resister is nothing but a 'clay' which will reduce the flow of current. There by limiting the volt.
current
A resistor is an electronic device that reduces the current flow in a circuit.
A resister limits the amount of current passing through a circuit.
Amperes
amperes or A.
It will not be possible to measure current unless the circuit is powered and operating.
An ammeter measured how many amperes of current are flowing in an electrical circuit.
No. A resister is not a replacement component for a diode. A resister is passive and allows current to flow through in in both directions. A diode is a single semiconductor junction that only allow current to flow in one direction.
The electrical current in a circuit is measured in amps.
Current is measured in a series circuit by the use of a multimeter. First, the power source must be attached to the circuit board. The board is attached to the multimeter, then that is attached back to the power source.AnswerCurrent is measured either with an ammeter, or with a multimeter set to measure current. The instrument must be connected in series with the other components in the circuit.
The unit for short circuit current is typically measured in amperes (A) or kiloamperes (kA). It represents the maximum current that can flow in a circuit under a short circuit condition.
Load resistors are connected across the circuit to limit the current flowing through the load.