answersLogoWhite

0

What else can I help you with?

Continue Learning about Engineering

What impact did water pump make in agriculture?

The impact that water pump made in agriculture is that it help people get water more easy. Matt Hunter Loves you<3


What are the examples of electricity in agriculture?

General use of electricity in agriculture is for pumping the water, using automated water sprinklers, running the bore well pump.


Why is lever action better for rifles and pump action better for shotguns?

They are both lever actions, in a way. It's a question of mechanics. Lever action rifles fell out of favor for a variety of reasons. Difficult to fire prone (lever travel), tubular magazines (blunt lead bullets only), loss of sight picture, I'm sure people can add their favorite. Pump actions weren't very popular for rifles for many of the same reasons. Tubular magazines aren't hazardous for shotguns because of the wide, blunt, plastic ends don't pose much hazard of igniting the round in front of it. The best shotguns in the world, and the best rifles for that matter, aren't lever action or pump, they are bolt or dual barrel.For firepower - Semi-auto gas or recoil w/ spring returnFor accuracy - Bolt/break actionFor a civilian compromise - lever action/pumpI've fired both. For a shotgun, fired at an angle from a standing position, the pump is more ergonomic than the lever. For a rifle, standing on a more horizontal plane, it comes down to preference.


What class lever is pliers?

The Class Lever for Pliers is a class 2 lever.


Is lathe a lever or not?

A lathe is not a lever.

Related Questions

Is that foot pump is third class lever?

Yes, a foot pump is a third class lever. The effort is applied between the load and the fulcrum.


Should the bike pump lever be positioned up or down when inflating a tire?

The bike pump lever should be positioned in the up position when inflating a tire.


What type of a lever is a hand pump?

It would be a lever class one lever as the fulcrum is in the middle


How to use a bike pump with a lever for optimal tire inflation?

To use a bike pump with a lever for optimal tire inflation, follow these steps: Attach the pump nozzle securely to the valve on the tire. Make sure the lever on the pump is in the correct position for inflation. Begin pumping air into the tire by pushing and pulling the lever. Monitor the pressure gauge on the pump to ensure you reach the recommended tire pressure. Once the tire is inflated to the desired pressure, remove the pump nozzle from the valve and secure the valve cap back on. By following these steps, you can effectively use a bike pump with a lever for optimal tire inflation.


What class of lever is water pump?

A water pump is typically a third-class lever, where the effort force is between the fulcrum and the load. The handle or lever is used to apply force to move the load (water) from a lower to a higher level.


What impact did water pump make in agriculture?

The impact that water pump made in agriculture is that it help people get water more easy. Matt Hunter Loves you<3


What are the uses of water pump in agriculture?

the water pump pumps water through pipelines to the crops


How do you tell when mechinal fuel pump fails?

The first thing you may notice is the engine will become hard to start. You may also notice gasoline mixed with the oil as the diaphragm in the pump may have a hole in it allowing fuel to enter the engine oil pan. Eventually the engine will not run at all from lack of fuel when the pump fails completely. You can test the pump by removing it and pushing the lever on the pump all the way in, then put your finger over the inlet and release the lever. If the diaphragm is busted the lever will move back. If the lever holds steady as long as you have the inlet plugged the pump is good.


Why is a 1989 polaris 500 not getting oil?

Make sure line to pump is not plugged. Make sure lever on pump is moving with throttle lever. There is a line on the pump and lever that must match up when throttle is closed. Remove oil lines from carbs, pull over to see if you have oil. If all checks out and no oil yet at the carb lines you may have some wrong in the pump drive.


How does a cast iron hand water pump work?

A cast iron hand water pump works by manually pumping a lever up and down. This action creates a vacuum within the pump, pulling water up through a pipe from a well or other water source. The water is then pushed out through a spout when the lever is pushed down.


How does an ejector pump work?

As the float rises it lifts an electric switch lever which energizes the pump to remove effluent. As the water level decreases the float weight puts a strain in the switch lever and the pump shuts off until the water level rises again


My fuel rod for the fuel pump is not engaging the with the pump lever how do i repair this?

you don't have the fuel pump in right if it's doing that, take it back out and try again.